Features: •Single 3.3v power supply•Eight Philips industry standard full duplex UART channels•Sixteen byte receiver FIFOs for each UART•Sixteen byte transmit FIFOs for each UART•In band flow control using programmable Xon/Xoff characters•Flow control using CTSN ...
SC26C198: Features: •Single 3.3v power supply•Eight Philips industry standard full duplex UART channels•Sixteen byte receiver FIFOs for each UART•Sixteen byte transmit FIFOs for each U...
SeekIC Buyer Protection PLUS - newly updated for 2013!
268 Transactions
All payment methods are secure and covered by SeekIC Buyer Protection PLUS.
SYMBOL |
PARAMETER |
RATING |
UNIT |
TA |
Operating ambient temperature range |
See Note 3 |
°C |
TSTG |
Storage temperature range |
-65 to +150 |
°C |
VCC |
Voltage from VDDto GND |
-0.5 to +7.0 |
V |
VSS |
Voltage from any pin to GND |
-0.5 to VCC+ 0.5 |
V |
PD5 |
Power Dissipation at VCC= 5.0 Volts |
1.2 |
W |
PD3 |
Power Dissipation at VCC= 3.3 Volts |
0.5 |
W |
The Philips 26C198 Octal UAR T is a single chip CMOSLSI communications device that provides 8 full-duplex asynchronous channels with significantly deeper 16 byte FIFOs, Automatic inband flow control using Xon/Xoff characters defined by the user and address recognition in the wake up mode. Synchronous bus interface is used for all communication between host and OCTART.It is fabricated using Philips 1.0 micron CMOS technology that combines the benefits of low cost, high density and low power consumption.
The operating speed of each receiver and transmitter can beselected independently from one of 22 fixed baud rates, a 16X clock derived from one of two programmable baud rate counters or one of three external 16X clocks (1 available at 1x clock rate). The baud rate generator and counter can operate directly from a crystal or from seven other external or internal clock inputs. The ability to independently program the operating speed of the receiver and transmitter makes the Octal UART particularly attractive for dual speed full duplex channel applications such as clustered terminal systems. The receivers and transmitters are buffered with FIFOs of 16 characters to minimize the potential for receiver overrun and to reduce interrupt overhead. In addition, a handshaking capability and inband flow control are provided to disable a remote UART transmitter when the receiver buffer is full or nearly so.
To minimize interrupt overhead an interrupt arbitration system is included which reports the context of the interrupting UART viadirect access or through the modification of the interrupt vector. The context of the interrupt is reported as channel number, type of device interrupting ( receiver COS etc.) and, for transmitters or receivers, the fill level of the FIFO.
The Octal UART provides a power down mode in which the oscillator is stopped but the register contents are maintained. This results in reduced power consumption of several orders of magnitudes. The Octal UART is fully TTL compatible whenoperating from a single +5V power supply. Operation at 3.3 volts is maintained with CMOS interface levels.
The device also offered in a version which maintains TTL input and output levels while operating with a 3.3 volt power supply.