Features: • Enhancement-Mode MOSFET Transistors (IDD0 @ VDD=12.8V, VGG1=VGG2=0V)• Pout>45W, T>33% @VDD=12.8V, VGG1=3.4V, VGG2=5V, Pin=50mW• Broadband Frequency Range: 896-941MHz• Metal cap structure that makes the improvements of RF radiation simple• Low-Power C...
RA45H8994M1: Features: • Enhancement-Mode MOSFET Transistors (IDD0 @ VDD=12.8V, VGG1=VGG2=0V)• Pout>45W, T>33% @VDD=12.8V, VGG1=3.4V, VGG2=5V, Pin=50mW• Broadband Frequency Range: 896-941...
SeekIC Buyer Protection PLUS - newly updated for 2013!
268 Transactions
All payment methods are secure and covered by SeekIC Buyer Protection PLUS.
SYMBOL |
PARAMETER |
CONDITIONS |
RATING |
UNIT |
VDD |
Drain Voltage | VGG1=3.4V ± 7%, VGG2<5V, Pin=0W |
17 |
V |
VGG1 |
Gate Voltage 1 | VGG2<5V, VDD<12.8V, Pin=50mW |
4.5 |
V |
VGG2 |
Gate Voltage 2 | VGG1=3.4V ± 7%, VDD<12.8V, Pin=50mW |
6 |
V |
Pin |
Input Power | f=896-941MHz, VGG1=3.4V ± 7%, VGG2<5V |
100 |
mW |
Pout |
Output Power |
60 |
W | |
Tcase(OP) |
Operation Case Temperature Range |
-30 to +100 |
°C | |
Tstg |
Storage Temperature Range |
-40 to +110 |
°C |
The RA45H8994M1 is a 45-watt RF MOSFET Amplifier Module for 12.8-volt mobile radios that operate in the 896- to 941-MHz range.
The battery can be connected directly to the drain of the enhancement-mode MOSFET transistors RA45H8994M1. Without the gate voltage 1 and the gate voltage 2(VGG1=VGG2=0V), only a small leakage current flows into the drain and the nominal output signal (Pout=45W) attenuates up to 60 dB. When fixed i.e. 3.4V, is supplied to the gate voltage 1, the output power and the drain current increase as the gate voltage 2 increases. The output power and the drain current increase substantially with the gate voltage 2 around 0V (minimum) under the condition when the gate voltage 1 is kept in 3.4V. The nominal output power becomes available at the state that VGG2 is 4V (typical) and 5V (maximum). At this point, VGG1 has to be kept in 3.4V.
At VGG1=3.4V & VGG2=5V, the typical gate currents are 0.4mA.This module RA45H8994M1 is designed for non-linear FM modulation, but may also be used for linear modulation by setting the drain quiescent current with the gate voltages and controlling the output power with the input power.