PVP2435

The PVP2435 is designed as 4 phase bipolar stepper motor drive board.

Some electrical specifications of PVP2435 have been concluded into several points as follow. The first one is about its motor supply which would be from +15 to +36 Vdc (+10% max) smoothed unregulated. The next one is about its logic supply which would be from +15 to +24 Vdc (+10% max) smoothed unregulated. The next one is about its AUX outputs which would be +12V regulated 50mA max and +5V regulated 50mA max are both available for external circuitry. The next one is about its motor drive output which would be bipolar chopped constant current with overload protection. 3.5A per phase max output - may be set lower by means of DIP switch or external resistor. Suitable for driving hybrid or permanent magnet motors with 4, 6, or 8 leads. The next one is about its control inputs which would be CMOS schmitt trigger inputs operating at +12V with 10k pull ups and diode isolation. Logic 0 (low): 0V to +2V or contact closure to 0V. Logic 1 (high): +9V to +30V max or open circuit. The next one is about its monitor outputs which would be open collector NPN transistor (ref. to 0V). Low level would be +1V max at 30mA max. High level would be open circuit +24Vdc max.

And also some mechanical and physical specifications about PVP2435. The first one si about its card size which would be eurocard format 60mm long X 100mm wide X 62mm high. The next one is about its weight which would be 700 grams approx. The next one is about its connector which would be 32 way PCB plug to DIN 41612 type D. The next one is about its printed circuit board which would be 1.6mm glass fibre with solder mask and component identification. The next one is about its temperature which means operating range would be from 0°C to +40°C max ambient. And so on. For more information please contact us.