PTN3332

Meets or exceeds the requirements of ANSI TIA/EIA-644 Standard
Designed for signaling rates of up to 400 Mbps
Differential input thresholds of ±100 mV
Power dissipation of 60 mW typical at 200 MHz
Typical propagation delay of 2.6 ns
Low Voltage TTL (LVTTL) logic output levels
Pin compatible with AM26LS32 and SN65LVDS32
Open-circuit fail safe.

 Low voltage, low EMI, high speed differential signal receiver
Point-to-point high speed data transmission
High performance switches and routers.

The PTN3332 is a differential line receiver that implements the electrical characteristics of Low-Voltage Differential Signaling (LVDS). This device meets or exceeds the requirements of the ANSI TIA/EIA-644 Standard. LVDS is used to
achieve higher data rates on commonly used media. LVDS overcomes the limitations of achievable slew rates and EMI restrictions of previous differential signaling techniques. The PTN3332 operates at a 3.3 volt supply level. Any of the four differential receivers provides a valid logical output state with a ±100 mV differential input voltage within the input common-mode voltage range. The input common-mode voltage range allows 1 volt of ground potential difference between two LVDS nodes.

The intended application of this device is for point-to-point baseband transmission rates over a controlled impedance media of approximately 100 W. The maximum rates and distance of data transfer are dependent upon the attenuation characteristics of the media selected and the noise coupling to the environment.

The PTN3332 is designed to function over the full industrial temperature range of -40 °C to +85 °C.