PP150T120-02

Features:

·High performance IGBT inverter bridge
·Integrated gate drive with fault monitoring & protection
·System status / troubleshooting LEDs to verify or monitor proper operation
·Isolated gate drive power supplies
·Low inductance laminated bus
·Output current measurement & feedback
·Superior short circuit detection & shoot through prevention


Specifications

General	Symbol		Units
IGBT Junction Temperature	Tj	-40 to +150	°C
Storage Temperature	Tstg	-40 to +125	°C
Operating Temperature	Top	-25 to +85	°C
Isolation Voltage, AC 1 minute, 60Hz sinusoidal	Viso	2500	Volts
SCR / Diode Converter
RMS Voltage Applied to AC Input Terminals	VL	550	Volts
Peak Transient Input Voltage	VLM	1600	Volts
IGBT Inverter
Collector Current (TC = 25°C)	IC	150	Amperes
Peak Collector Current (Tj < 150°C)	ICM	300	Amperes
Emitter Current	IE	150	Amperes
Peak Emitter Current	IEM	300	Amperes
Maximum Collector Dissipation (Tj < 150°C)	Pc	520	Watts
Gate Drive Board
Unregulated +24V Power Supply		30	Volts
Regulated +15V Power Supply		18	Volts
PWM Signal Input Voltage		20	Volts
Fault Output Supply Voltage		30	Volts
Fault Output Current		50	mA

Description

The PP150T120-02 Powerex POW-R-PAK^TM is a configurable IGBT based power assembly that may be used as a converter, chopper, half or full bridge, or three phase inverter for motor control, power supply, UPS or other power conversion applications.

The PP150T120-02 power assembly is mounted on a forced aircooled heatsink and features state-of-the-art Powerex F-series trench gate IGBTs with low conduction and switching losses for high efficiency operation. The POW-R-PAK^TM includes a low inductance laminated bus structure, optically isolated gate drive interfaces, isolated gate drive power supplies, and a DC-link capacitor bank. The control board provides a simple user interface along with built-in protection features including overvoltage,undervoltage lockout, overcurrent,overtemperature, and short circuit detection.

Depending on application characteristics the PP150T120-02 POW-R-PAK^TM is suitable for operation with DC bus voltages up to 800VDC and switching frequencies above 20kHz.