Features: • Near-Zero propagation delay• 5 switches connect inputs to outputs• Direct bus connection when switches are ON• Ultra-low quiescent power 32X384 (0.2A typical) Ideally suited for notebook applications• Packaging (Pb-free & Green Available): 48-pin 150-...
PI5C32X384C: Features: • Near-Zero propagation delay• 5 switches connect inputs to outputs• Direct bus connection when switches are ON• Ultra-low quiescent power 32X384 (0.2A typical) Id...
SeekIC Buyer Protection PLUS - newly updated for 2013!
268 Transactions
All payment methods are secure and covered by SeekIC Buyer Protection PLUS.
Above which the useful life may be impaired. For user guidelines, not tested.
Storage Temperature .............................................................65°C to +150°C
Ambient Temperature with Power Applied ............................40°C to +85°C
Supply Voltage to Ground Potential (Inputs & Vcc Only) ......0.5V to +7.0V
Supply Voltage to Ground Potential (Outputs & D/O Only) ...0.5V to +7.0V
DC Input Voltage .....................................................................0.5V to +7.0V
DC Output Current................................................................................120mA
Power Dissipation .................................................................................... 0.5W
Note:
Stresses greater than those listed under MAXIMUM RATINGS may cause permanent damage to the device. This is a stress rating only and functional operation of the device at these or any other conditions above those indicated in the operational sections of this specification is not implied. Exposure to absolute maximum rating conditions for extended periods may affect reliability.
Pericom Semiconductor's PI5C32X384 and PI5C32X384C are 20-bit bus switches designed with a low On-Resistance allowing inputs to be connected directly to outputs. The bus switch creates no additional propagational delay or additional ground bounce noise. The PI5C32X384 and PI5C32X384C switches are turned ON by the Bus Enable (BE) input signal. Four bus enable signals are provided, one for each of the upper and lower five bits of the two 10-bit buses.