Features: •Single Supply Operation (+2V to +6V)•Rail-to-Rail Analog Signal Dynamic Range•Low On-Resistance (6 typ with 5V supply) Minimizes Distortion and Error Voltages•On-Resistance Matching Between Channels, 0.4 Typ.•On-Resistance Flatness, <2 Typ.•Low Cha...
PI5A100: Features: •Single Supply Operation (+2V to +6V)•Rail-to-Rail Analog Signal Dynamic Range•Low On-Resistance (6 typ with 5V supply) Minimizes Distortion and Error Voltages•On-R...
SeekIC Buyer Protection PLUS - newly updated for 2013!
268 Transactions
All payment methods are secure and covered by SeekIC Buyer Protection PLUS.
Voltages Referenced to Gnd
VCC ........................................................................-0.5V to +7V
VIN, VCOM, VNC, VNO (1)..............................-0.5V to VCC +2V
..................................................or 30mA, whichever occurs first
Current (any terminal except COM, NO, NC).................. 30mA
Current, COM, NO, NC
(pulsed at 1ms, 10% duty cycle) ..................................... 120mA
Continuous Power Dissipation
Narrow SOIC & QSOP
(derate 8.7mW/ºC above +70ºC) . . . . . . . . . . . . . . . . . 650mW
Storage Temperature . . . . . . . . . . . . . . . . . . . . -65ºC to +150ºC
Lead Temperature (soldering, 10s) . . . . . . . . . . . . . . . . +300ºC
Notes:
1. Signals on NC, NO, COM, or IN exceeding VCC or GND are clamped by internal diodes. Limit forward diode current to 30mA.
2. Caution: Stresses beyond those listed under "Absolute Maximum Ratings" may cause permanent damage to the device. This is a stress only rating and operation of the device at these or any other conditions beyond those ndicated in the operational sections of this speci fication is not implied.
(4SPDT) CMOS analog switch designed to operate with a single +2V to +6V power supply. The EN pin may be used to place all switches in a high-impedance state. This high precision device is ideal for low-distortion audio, video, and data switching and routing.Each PI5A100 switch conducts current equally well in either direction when on. In the off state each switch blocks voltages up to the power-supply rails.
The PI5A100 is fully specified with +5V, and +3.3V supplies. With +5V, it guarantees less than 10 On-Resistance. On-Resistance matching between channels is within 2. On-Resistance flatness is less than 4 over the specified range. The PI5A100 guarantees fast switching speeds (tON < 12ns).
The PI5A100 is available in the narrow-body SOIC and QSOP packages for operation over the industrial (-40°C to +85°C) temperature range.