PDI1394L41

` IEEE1394.a and IEEE13941995 Standard Link Layer Controller
` Hardware Support for the IEC61883 International Standard of Digital Interface for Consumer Electronics
` Interface to any IEEE 13941995 or 1394.a Physical Layer Interface
` 5V Tolerant I/Os
` Single 3.3V supply voltage
` Full-duplex isochronous operation
` Operates with 400/200/100 Mbps physical layer devices
` 12K byte fully programmable FIFO pool for isochronous and asynchronous data
` Supports single capacitor isolation mode and IEEE 13941995, Annex J. isolation
` 6-field deep SYT buffer added to enhance real-time isochronous synchronization using the AVFSYNC pin
` Generates its own AV port clocks under software control. Select one of three frequencies: 24.576, 12.288, or 6.144 MHz
` Hardware support for the "5C" content protection method
` On chip timer resources
` Flexible 8/16 bit multiplexed/non-multiplexed host interface ` Parallel AV interface
` Fast 56-bit M6 cipher/decipher blocks capable of operating at over 80 Mbps
` Hardware authentication acceleration to reduce software processor loading
` Highly configurable 12 K byte FIFO

NOTES:
1. Stresses beyond those listed may cause permanent damage to the device. These are stress ratings only and functional operation of the device at these or any other conditions beyond those indicated under "recommended operating conditions" is not implied. Exposure to absolute-maximum-rated conditions for extended periods may affect device reliability.

2. The performance capability of a high-performance integrated circuit in conjunction with its thermal environment can create junction temperatures which are detrimental to reliability. The maximum junction temperature of this integrated circuit should not exceed 150°C.

The PDI1394L41, Philips Semiconductors Full Duplex 1394 Audio/Video (AV) Link Layer Controller, is an IEEE 13941995 compliant link layer controller featuring 2 embedded AV layer interfaces. The AV layers are designed to encrypt and pack, or unpack and decrypt application data packets for transmission over the IEEE1394 bus using isochronous data transfers and the "5C" content protection method.

The application data of PDI1394L41 is packetized according to the IEC 61883 International Standard of Interface for Consumer Electronic Audio/Video Equipment. Both AV layer interfaces are byte-wide ports capable of accommodating various MPEG2 and DVC codecs. A flexible host interface is provided for internal register configuration as well as performing asynchronous data transfers.

Both 8 bit and 16 bit wide data paths, as well as multiplexed/non-multiplexed access modes are supported.

The PDI1394L41 is powered by a single 3.3V power supply and the inputs and outputs are 5V tolerant. It is available in the LQFP144 package.