OPL583

Standard Pack Qty :
Product : Photo IC
Output Type : Open Collector
Operating Supply Voltage : 4.5 V to 16 V
Maximum Operating Temperature : + 85 C
Minimum Operating Temperature : - 40 C
Fall Time : 15 ns
High Level Output Current : 1 uA
Number of Channels : 2
Supply Current : 8.5 mA
Rise Time : 20 ns
Propagation Delay Time : 10 us


Features:

·Two matched de tectors with pho tolithographic con trol of rela tive po sition
·Dual Pho tologic^® cir cuitry in sin gle package pro vides re duced com ponent count
·Open col lector inverter out put for flexi - bility of cir cuit in terface
·Low cost plas tic hous ing


Specifications

Sup ply Volt age. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 18 V⁽⁵⁾
Storage Tem perature . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .  . .-40 to +100
Operate Tem perature. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .  . .-40 to +85
Lead Sol der Tem perature [1/16 inch (1.6 mm) from case for 5 sec. with sol dering iron]
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .  260o C⁽²⁾
Power Dis sipation . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .  200 mW⁽¹⁾
Duration of Out put Short to V_CC. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .  1.00 sec.
Voltage At Out put . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 18 V
Low Level Out put Cur rent (sink ing) . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 40 mA

(1) Derate linearly 2.67 mW/ above 25.
(2) RMA flux is recommended. Duration can be extended to 10 sec. max when flow soldering.
Max 20 grams force may be applied to leads when flow soldering.
(3) A 0.01 F capacitor should be used across the V_CC and GND leads to stabilize the power
supply line.
(4) Irradiance measurements are made with l = 940 nm.
(5) Derate linearly 0.37 V/ above 58.


Description

The OPL583 contains a monolithic integrated circuit which incorporates two independent photodiodes, linear amplifiers, Schmitt trigger circuits, and output transistors served by a common voltage regulator. The outputs are TTL/LSTTL compatible and can drive 8 TTL loads over a voltage range from 4.5 to 16 V. Applications include linear and rotary encoders with resolutions determined by external apertures. The fixed relative position of the two photodiodes and the matched characteristics of the two channels allow considerable design flexibility.


Parameters:

Technical/Catalog Information	OPL583
Vendor	TT Electronics/Optek Technology
Category	Sensors, Transducers
Lead Free Status	Lead Free
RoHS Status	RoHS Compliant
Other Names	OPL583 OPL583