Features: · INTERNALLY FIXED GAIN: +2 OR ±1· HIGH BANDWIDTH (G = +2): 240MHz· LOW SUPPLY CURRENT: 6mA· LOW DISABLED CURRENT: 320mA· HIGH OUTPUT CURRENT: 150mA· OUTPUT VOLTAGE SWING: ±4.0V· ±5V OR SINGLE +5V OPERATION·SOT23-6 AVAILABLEApplication· BROADBAND VIDEO LINE DRIVERS· VIDEO MULTIPLEXERS· M...
OPA682: Features: · INTERNALLY FIXED GAIN: +2 OR ±1· HIGH BANDWIDTH (G = +2): 240MHz· LOW SUPPLY CURRENT: 6mA· LOW DISABLED CURRENT: 320mA· HIGH OUTPUT CURRENT: 150mA· OUTPUT VOLTAGE SWING: ±4.0V· ±5V OR SI...
SeekIC Buyer Protection PLUS - newly updated for 2013!
268 Transactions
All payment methods are secure and covered by SeekIC Buyer Protection PLUS.
US $3.87 - 5.13 / Piece
Operational Amplifiers - Op Amps High-Speed Precision Difet
The OPA682 provides an easy to use, broadband fixed gain buffer amplifier. Depending on the external connections, the internal resistor network may be used to provide either a fixed gain of +2 video buffer or a gain of +1 or 1 voltage buffer. Operating on a very low 6mA supply current, the OPA682 offers a slew rate and output power normally associated with a much higher supply current. A new output stage architecture delivers high output current with a minimal headroom and crossover distortion. This gives exceptional single supply operation. Using a single +5V supply, the OPA682 can deliver a 1V to 4V output swing with over 100mA drive current and 200MHz bandwidth. This combination of features makes the device an ideal RGB line driver or single supply ADC input driver.The OPA682's low 6mA supply current is precisely trimmed at 25. This trim, along with low drift over temperature, guarantees lower maximum supply current than competing products that report only a room temperature nominal supply current. System power may be further reduced by using the optional disable control pin. Leaving this disable pin open, or holding it high, gives normal operation. If pulled low, the OPA682 supply current drops to less than 320mA while the output goes into a high impedance state. This feature may be used for either power savings or for video MUX applications.