Function: Tri-State (Output Enable)
Operating Temperature: -40°C ~ 85°C
Ratings: -
Mounting Type: Surface Mount
Packaging: Tape & Reel (TR)
Frequency Stability: ±100ppm
Current - Supply (Max): 70mA
Series: -
Manufacturer: RFM
Output: -
Type: VCSO (SAW)
Package / Case: 8-SMD
Voltage - Supply: 3.13V ~ 5.25V
Size / Dimension: 0.530" L x 0.360" W (13.46mm x 9.14mm)
Height: 0.076" (1.93mm)
Frequency: 666.51MHz
Features: • Quartz SAW Stabilized and Filtered "Diff Sine" Technology
• Fundamental-Mode Oscillation at 666.51 MHz
• Voltage Tunable for Phase Lock Loop Operations
• Optical Timing Reference for Forward Error Correction ApplicationsSpecifications
| Rating |
Value |
Units |
| DC Suppy Voltage |
0 to 5.5 |
Vdc |
| Tuning Voltage |
0 to 6 |
Vdc |
| Case Temperature |
-55 to 100 |
°C |
Characteristic Symbol Minimum Typical Maximum Units Operating Frequency Absolute Frequency fO 666.51 MHz Tuning Range 100 ppm Tuning Voltage 0 +3 VDC Tuning Linearity 3% Tuning Sensitivity df/dv 140 300 ppm/V Modulation Bandwidth 125 265 kHz Q and Q Output Voltage into 50 Ohm (VSWR ? 1.2) VO 0.60 1.1 VP-P Operating Load VSWR 2:1 VP-P Symmetry 49 51 % Harmonic Spurious -30 dBc Nonharmonic Spurious -60 dBc Phase Noise dBc/Hz @ 100 Hz offset -75 dBc/Hz Phase Noise @ 1 kHz offset -105 dBc/Hz Phase Noise @ 10 kHz offset -125 dBc/Hz Noise Floor -155 dBc/Hz Q and Q Jitter RMS Jitter 2 PSP-P No Noise on VCC 12 PSP-P 200 mVP-P Noise from 1 MHz to fO on VCC 12 PSP-P Input Impedence (Tuning Port) 1 KOhm Output DC Resistance (between Q & Q) 50 KOhm DC Power Supply Operating Voltage VCC 3.13 3.3 5.0 5.25 VDC Operating Current ICC 70 mA Operating Case Temperature TC -40C +85C C
DescriptionThe output of this device OP4006B is generated and filtered by narrowband quartz SAW elements at 666.51 MHz. The confi-guration of this clock OP4006B is intended to provide a pure signal for optical timing applications in noisy signal environments. The Q/Qbar differential output swing of ±1 volt about 0 vdc has symmetry better than ±1% into loads from 40 ohms to 70 ohms; determined by customer application. The long term frequency accuracy is set by an external reference source allowing this device to complete a Phase Lock Loop design without the usual noise and jitter problems ass-ociated with PLL's.
OP4006B Data Sheet
