Features: • 5.0 V ± 2.0% Output• Low 150 A Quiescent Current• Active Reset Output Low Down to VQ = 1.0 V• Adjustable Reset Threshold• 150 mA Output Current Capability• Fault Protection ♦ +60 V Peak Transient Voltage ♦ −40 V Reverse Voltage ...
NCV4279: Features: • 5.0 V ± 2.0% Output• Low 150 A Quiescent Current• Active Reset Output Low Down to VQ = 1.0 V• Adjustable Reset Threshold• 150 mA Output Current Capability&...
SeekIC Buyer Protection PLUS - newly updated for 2013!
268 Transactions
All payment methods are secure and covered by SeekIC Buyer Protection PLUS.
Parameter |
Symbol |
Min |
Max |
Unit |
Input to Regulator |
VI |
−40 Internally Limited |
45 Internally Limited |
V |
Input Peak Transient Voltage |
VI |
− |
60 |
V |
Sense Input |
VSI |
−40 −1 |
45 1 |
V mA |
Reset Threshold Adjust |
VRADJ IRADJ |
−0.3 −10 |
7 10 |
V mA |
Reset Delay |
VD ID |
−0.3 Internally Limited |
7 Internally Limited |
V |
Ground |
Iq |
50 |
− |
mA |
Reset Output |
VRO IRO |
−0.3 Internally Limited |
7 Internally Limited |
V |
Sense Output |
VSO ISO |
−0.3 Internally Limited |
7 Internally Limited |
V |
Regulated Output |
VQ IQ |
−0.5 −10 |
7.0 − |
V mA |
Junction Temperature Storage Temperature |
TJ TSTG |
− −50 |
150 150 |
°C °C |
Input Voltage Operating Range Junction Temperature Operating Range |
VI TJ |
− −40 |
45 150 |
V °C |
Junction−to−Ambient Thermal Resistance SO−8 SO−14 |
RJA |
− |
200 70 |
k/W |
Junction−to−Pin 4, all GND Pins Grounded. SO−14 |
RJP |
− |
30 |
k/W |
only 150 A with a 1.0 mA load. This NCV4279 part is ideal for any and all battery operated microprocessor equipment.Microprocessor control logic includes an active reset output RO with delay and a SI/SO monitor which can be used to provide an early warning signal to the microprocessor of a potential impending reset signal. The use of the NCV4279 SI/SO monitor allows the microprocessor to finish any signal processing before the reset shuts the microprocessor down.
The NCV4279 active Reset circuit operates correctly at an output voltage as low as 1.0 V. The Reset function is activated during the power up sequence or during normal operation if the output voltage drops outside the regulation limits.
The reset threshold voltage of NCV4279 can be decreased by the connection of an external resistor divider to the RADJ lead. The regulator is protected against reverse battery, short circuit, and thermal overload conditions.
The NCV4279 can withstand load dump transients making it suitable for use in automotive environments. The device has also been optimized for EMC conditions.If the application requires pullup resistors at the logic outputs Reset and Sense Out, the NCV4269 with integrated resistors can be used.