Features: · Meets TIA/EIA-603 Standards· 47 CTCSS Tones + Notone· TX/RX Speech Filters· Improved Sinad· Serial or Parallel Programming· Easy µP Interface· Scanning on any Channel· Standard 4MHz Xtal (See MX165C for 1MHz)· Low Voltage 3.3V to 5.0VApplication· Mobile Radio Channel Sharing· Sca...
MX465: Features: · Meets TIA/EIA-603 Standards· 47 CTCSS Tones + Notone· TX/RX Speech Filters· Improved Sinad· Serial or Parallel Programming· Easy µP Interface· Scanning on any Channel· Standard 4MH...
SeekIC Buyer Protection PLUS - newly updated for 2013!
268 Transactions
All payment methods are secure and covered by SeekIC Buyer Protection PLUS.
General |
Notes |
Min. |
Typ. |
Max. |
Units |
Supply (VDD-VSS) |
-0.3 |
7.0 |
V | ||
Voltage on any pin to VSS |
-0.3 |
VDD + 0.3 |
V | ||
Current | |||||
VDD |
-30 |
30 |
mA | ||
VSS |
-30 |
30 |
mA | ||
Any other pins |
-20 |
20 |
mA | ||
TN / DW / LH / DIP Package | |||||
Total allowable Power issipation at TAMB = 25 |
800 |
mW | |||
Derating above 25 |
10 |
mW/ above 25 | |||
Storage Temperature |
-55 |
125 |
| ||
Operating Temperature |
-40 |
85 |
| ||
DS Package | |||||
Total allowable Power dissipation at TAMB = 25 |
550 |
mW | |||
Derating above 25 |
9 |
mW/ above 25 | |||
Storage Temperature |
-55 |
125 |
| ||
Operating Temperature |
-40 |
85 |
|
The MX465 CTCSS Encoder/Decoder is a low voltage, CMOS device that meets TIA/EIA-603 Standards. The MX465 will encode and decode the tones 159.8Hz, 183.5Hz, 189.9Hz, 196.6Hz, 199.5Hz, 206.5Hz, 229.1Hz, and 254.1Hz in addition to the 39 standard CTCSS tones, for a total of 47 CTCSS tones + Notone. With the incorporation of the on-chip TX and RX speech filter, the MX465 enhances voice/tone multiplexing by attenuating TX and RX speech 36dB at frequencies below 250Hz while passing signals > 300Hz with only 1dB of ripple. This not only minimizes CTCSS talk-off in the TX mode but also improves Hum and Noise performance in the RX mode.
Available in the following package styles: 24-pin TSSOP (MX465TN), 24-pin SSOP (MX465DS), 24-pin SOIC (MX465DW), 24-pin PLCC (MX465LH), 24-pin PDIP (MX465P), and 24-pin CDIP (MX465J) the MX465 requires a single 3.3V to 5.0V supply and a 4MHz clock or crystal.