Features: * 2.5V to 10V input voltage
* Output voltage up to 34V
* 1.2A switch current
* 1.2MHz PWM operation
* 95mV feedback voltage
* Overvoltage protection (OVP)
Options for 15V and 34V
* Stable with ceramic capacitors
* <1% line and load regulation
* 1A shutdown current
* Over temperature protection
* UVLO
* Low-profile Thin SOT23-5 package option
* 2mm * 2mm MLF(TM) package option
*40°C to +125°C junction temperature rangeApplication* Photo Flash LED driver
* Cell phones
* PDAs
* GPS systems
* Digital cameras
* IP phones
* LED flashlightsPinout
SpecificationsSupply Voltage (V IN) .....................................................12V
Switch Voltage (V SW)..................................... 0.3V to 34V
Enable Pin Voltage (V EN )...................................0.3 to V IN
FB Voltage (V FB).............................................................6V
Switch Current (ISW) .......................................................2A
Ambient Storage Temperature (TS ) .........65°C to +150°C
ESD Rating (3) ................................................................2kVDescriptionThe MIC2291 is a 1.2MHz Pulse Width Modulation (PWM), boost-switching regulator that is optimized for high-current, white LED photo flash applications. With a guaranteed switch current of 1.2A, the MIC2291 easily drives a string of 3 white LEDs in series at 100mA, ensuring a high level of brightness and eliminating several ballast resistors.
The MIC2291 implements a constant frequency, 1.2MHz PWM control scheme. The high frequency PWM operation saves board space by reducing external component sizes. The added benefit of the constant frequency PWM scheme, in contrast to variable frequency topologies, MIC2291 is much lower noise and input ripple injected back to the battery source.
To optimize efficiency, the feedback voltage is set to only 95mV. This reduces the power dissipation in the current set resistor, and allows the lowest total output voltage, hence minimal current draw from the battery.
The MIC2291 is available with 2 levels of over-voltage protection, 15V, and 34V. This allows designers to choose the smallest possible external components with the appropriate voltage ratings for their applications.
The MIC2291 is available in low-profile, Thin SOT23 5-lead and 8-lead 2mm x 2mm MLF package options. The MIC2291 has a junction temperature range of 40°C to +125°C.
All support documentation can be found on Micrel's web site at www.micrel.com.
MIC2291 Data Sheet
