MCM36F9

Pinout




Specifications

Rating	Symbol	Value	Unit
Power Supply Voltage	VCC	0.5to+4.6	V
Voltage Relative to VSS For Any Pin Except VCC	Vin, Vout	0.5 to VCC + 0.5	V
Output Current (per I/O)	Iout	± 20	mA
Temperature Under Bias	Tbias	10to+85	°C
Storage Temperature - Plastic	Tstg	55 to + 125	°C

NOTE: Permanent device damage may occur if ABSOLUTE MAXIMUM RATINGS are exceeded. Functional operation should be restricted to RECOMMENDED OPERATING CONDITIONS. Exposure to higher than recommended voltages for
extended periods of time could affect device reliability.

Description

The MCM36F8 (1MB) is configured as 256K x 36 bits and the MCM36F9 (2MB) is configured as 512K x 36 bits. Both are packaged in a 144pin dualinline memory module (DIMM). Each module uses Motorola's 3.3 V 256K x 18 bit flow through BurstRAMs.

  Address (A), data inputs (DQ, DP), and all control signals except output enable (G) are clock (K) controlled through positiveedgetriggered noninverting registers.

Write cycles are internally selftimed and initiated by the rising edge of the clock (K) input. This feature provides increased timing flexibility for incoming signals. Synchronous byte write (BWx) and global byte write (WE) allows writes to either individual bytes or to both bytes.
• Single 3.3 V + 10%, 5% Power Supply
• Multiple Clock Pins for Reduced Loading
• All Inputs and Outputs are LVTTL Compatible
• Byte Write and Global Write Capability
• Fast SRAM Access Times: 10 ns
• Berg Connector, Part Number: 6117831844
• 144Pin DIMM Module