MC33207

NOTES: 1. The differential input voltage of each amplifier is limited by two internal parallel backtoback diodes. For additional differential input voltage range, use current limiting resistors in series with the input pins.
2. The commonmode input voltage range of each amplifier is limited by diodes connected from the inputs to both power supply rails. Therefore, the voltage on either input must not exceed either supply rail by more than 500 mV.
3. Power dissipation must be considered to ensure maximum junction temperature (T_J) is not exceeded.
4. ESD data available upon request.

The MC33206/7 family of operational amplifiers provide railtorail operation on both the input and output. The inputs can be driven as high as 200 mV beyond the supply rails without phase reversal on the outputs and the output can swing within 50 mV of each rail. This railtorail operation enables the user to make full use of the supply voltage range available. MC33206/7 is designed to work at very low supply voltages (±0.9 V) yet can operate with a single supply of up to 12 V and ground. Output current boosting techniques provide a high output current capability while keeping the drain current of the amplifier to a minimum.

The MC33206/7 has an enable mode that can be controlled externally.

The MC33206/7 supply current in the standby mode is <1.0 A (V_Enable = Gnd).

The addition of an enable function makes MC33206/7 an ideal choice for power sensitive applications, battery powered equipment (instrumentation and monitoring), portable telecommunication, and sampleandhold applications.
• Standby Mode (I_D 1.0 A, Typ)
• Low Voltage, Single Supply Operation (1.8 V and Ground to 12 V and Ground)
• RailtoRail Input Common Mode Voltage Range
• Output Voltage Swings within 50 mV of both Rails
• No Phase Reversal on the Output for OverDriven Input Signals
• High Output Current (I_SC = 80 mA, Typ)
• Low Supply Current (I_D = 0.9 mA, Typ)
• 600 W Output Drive Capability
• Typical Gain Bandwidth Product = 2.2 MHz