Features: ` 0.2% Max Initial Accuracy
` 20ppm/°C Max Temperature Coefficient
` 35A Max Quiescent Supply Current
` 0.8A/V Supply Current Variation with VIN
` ±500A Output Source and Sink Current
` 100mV Dropout at 500A Load Current
` 0.12V/A Load Regulation
` 8V/V Line Regulation
` Stable with CLOAD = 0 to 2.2nFApplication · Hand-Held Equipment
· Data Acquisition Systems
· Industrial and Process-Control Systems
· Battery-Operated Equipment
· Hard-Disk DrivesPinout
Specifications(Voltages Referenced to GND)
IN .........................................................................-0.3V to +13.5V
OUT ...............................................................-0.3V to (VIN + 0.3V)
Output Short Circuit to GND or IN (VIN < 6V) ..............Continuous
Output Short Circuit to GND or IN (VIN ³ 6V) ......................60sec
Continuous Power Dissipation (TA = +70°C)
SOT23-3 (derate 4.0mW/°C above +70°C).....................320mW
Operating Temperature Range ..........................-40°C to +85°C
Storage Temperature Range ...........................-65°C to +150°C
Lead Temperature (soldering, 10sec) ............................+300°C
Stresses beyond those listed under "Absolute Maximum Ratings" may cause permanent damage to the device. These are stress ratings only, and functional operation of the device at these or any other conditions beyond those indicated in the operational sections of the specifications is not implied. Exposure to absolute maximum rating conditions for extended periods may affect device reliability.
DescriptionThe MAX6012/MAX6021/MAX6025/MAX6030/MAX6041/MAX6045/MAX6050 precision, low-dropout, micropower voltage references are available in miniature SOT23-3 surface-mount packages. They feature a proprietary curvature-correction circuit and laser-trimmed thin-film resistors that result in a low temperature coefficient of <20ppm/°C and initial accuracy of better than 0.2%. These devices are specified over the extended temperature range.
The MAX6012 mode voltage references draw only 27A of quiescent supply current and can sink or source up to 500A of load current. Unlike conventional shuntmode (two-terminal) references that waste supply current and require an external resistor, devices in the MAX6012 family offer a supply current that's virtually independent of supply voltage (with only a 0.8A/V variation with supply voltage) and do not require an external resistor. Additionally, these internally compensated devices do not require an external compensation capacitor and are stable with up to 2.2nF of load capacitance. Eliminating the external compensation capacitor saves valuable board area in space-critical applications. Their low dropout voltage and supply-independent, ultra-low supply current make these devices ideal for battery-operated, low-voltage systems.
MAX6012 Data Sheet
