MAX5918

Safe Hot Swap for +1V to +13.2V Power Supplies with VIN1 or VIN2 2.7V
 Independent On/Off Control for Each Channel
 Internal Charge Pumps Generate N-Channel MOSFET Gate Drives
 Inrush Current Regulated at Startup
 Circuit Breaker Function
 Adjustable Circuit Breaker/Current-Limit Threshold from 25mV to 100mV
 VariableSpeed/BiLevel Circuit Breaker Response
 Autoretry or Latched Fault Management
 Status Outputs Indicate Fault/Safe Condition
 Output Undervoltage and Overvoltage Monitoring or Protection

Base Station Line Cards                       Power-Supply Sequencing

Network Switches,                               Hot Plug-In Daughter
Routers, Hubs                                      Cards

Solid-State Circuit                                Portable Computer Device
Breakers                                              Bays (Docking Stations)

RAID

IN_ to GND...........................................................................+14V
GATE_ to GND ...........................................-0.3V to (V_IN_ + 6.2V)
ON_, PGOOD_, TIM to GND.........................-0.3V to the higher of
                                                   (VIN1 + 0.3V) and (V_IN2 + 0.3V)
SENSE_, MON_, LIM_ to GND ...................-0.3V to (V_IN_ + 0.3V)
Current into Any Pin .........................................................±50mA
Continuous Power Dissipation (T_A = +70°C)
   16-Pin QSOP (derate 8.3mW/°C above +70°C)...........667mW
Operating Temperature Range ...........................-40°C to +85°C
Storage Temperature Range ............................-65°C to +150°C
Lead Temperature (soldering, 10s) ..................................+300°C

The MAX5918 and MAX5919 are +1V to +13.2V dual hot-swap controllers with independent on/off control for complete protection of dual-supply systems. They allow
the safe insertion and removal of circuit cards into live backplanes. The MAX5918 and MAX5919 operate down to 1V provided one of the inputs is above 2.7V

The discharged filter capacitors of the circuit card provide low impedance to the live backplane. High inrush currents from the backplane to the circuit card can burn
up connectors and components, or momentarily collapse the backplane power supply leading to a system reset. The MAX5918 and MAX5919 hot-swap controllers prevent
such problems by gradually ramping up the output voltage and regulating the current to a preset limit when the board is plugged in, allowing the system to stabilize
safely. After the startup cycle is completed, two on-chip comparators provide VariableSpeed/BiLevel™ protection against short-circuit and overcurrent faults, as well as
immunity against system noise and load transients. In the event of a fault condition, the load is disconnected. The MAX5918L and MAX5919L must be unlatched after a
fault and the MAX5918A and MAX5919A automatically restart after a fault.

The MAX5918 and MAX5919 integrate an on-board charge pump to drive the gates of low-cost, external Nchannel MOSFETs. The devices offer integrated features like startup current regulation and current glitch protection to eliminate external timing resistors and capacitors. These devices provide open-drain status outputs, an adjustable startup timer and adjustable current limits. The MAX5918 provides output undervoltage/ overvoltage protection for each channel, while the MAX5919 provides undervoltage/overvoltage monitoring for each channel.

The MAX5918 and MAX5919 are available in a spacesaving 16-pin QSOP package and are specified over the extended -40°C to +85°C temperature range.