Features: · Ultra-Low Supply Current115µA at VDD = 3.6V 135µA at VDD = 5.5V· 300nA Low-Power Power-Down Mode· Single 2.7V to 5.5V Supply Voltage· Fast 400kHz I2C-Compatible 2-Wire Serial Interface· Schmitt-Trigger Inputs for Direct Interfacing to Optocouplers· Rail-to-Rail Output Buffe...
MAX5822: Features: · Ultra-Low Supply Current115µA at VDD = 3.6V 135µA at VDD = 5.5V· 300nA Low-Power Power-Down Mode· Single 2.7V to 5.5V Supply Voltage· Fast 400kHz I2C-Compatible 2-Wire Serial...
SeekIC Buyer Protection PLUS - newly updated for 2013!
268 Transactions
All payment methods are secure and covered by SeekIC Buyer Protection PLUS.
Features: ·+5V at 10A Output·±36V to ±72V Input Voltage Range·250kHz Switching Frequency·Fully Iso...
VDD, SCL, SDA to GND............................................-0.3V to +6V
OUT_, REF, ADD to GND..............................-0.3V to VDD + 0.3V
Maximum Current into Any Pin......................................... 50mA
Continuous Power Dissipation (TA = +70°C)
8-Pin µMAX (derate 4.5mW above +70°C) .................362mW
Operating Temperature Range ....................-40°C to +85°C
Storage Temperature Range ......................-65°C to +150°C
Maximum Junction Temperature .................................+150°C
Lead Temperature (soldering, 10s) ............................+300°C
Stresses beyond those listed under "Absolute Maximum Ratings" may cause permanent damage to the device. These are stress ratings only, and functional operation of the device at these or any other conditions beyond those indicated in the operational sections of the specifications is not implied. Exposure to absolute maximum rating conditions for extended periods may affect device reliability.
The MAX5822 is a dual, 12-bit, voltage-output, digital-toanalog converter (DAC) with an I2C™-compatible, 2-wire interface that operates at clock rates up to 400kHz. The device operates from a single 2.7V to 5.5V supply and draws only 115µA at VDD = 3.6V. A power-down mode decreases current consumption to less than 1µA. The MAX5822 features three software-selectable powerdown output impedances: 100kΩ, 1kΩ, and high impedance. Other features include internal precision Rail-to-Rail® output buffers and a power-on reset (POR) circuit that powers up the DAC in the 100kΩ power-down mode.
The MAX5822 features a double-buffered I2C-compatible serial interface that allows multiple devices to share a single bus. All logic inputs are CMOS-logic compatible and buffered with Schmitt triggers, allowing direct interfacing to optocoupled and transformer-isolated interfaces.
The MAX5822 minimizes digital noise feedthrough by disconnecting the clock (SCL) signal from the rest of the device when an address mismatch is detected. The MAX5822 is specified over the extended temperature range of -40°C to +85°C and is available in a miniature 8-pin µMAX package. Refer to the MAX5821 data sheet for the 10-bit version.