MAX5094D

The MAX5094A/B/C/MAX5094D/MAX5095A/B/C BiCMOS, highperformance, current-mode PWM controllers have all the features required for wide input-voltage range isolated/nonisolated power supplies. These controllers are used for low- and high-power universal input voltage and telecom power supplies. The MAX5094D/MAX5095D contain a fast comparator with only 60ns typical delay from current sense to the output for overcurrent protection. The MAX5094D has an integrated error amplifier with the output at COMP. Softstart is achieved by controlling the COMP voltage rise using external components.

The oscillator frequency of MAX5094D is adjustable from 20kHz to 1MHz with an external resistor and capacitor. The timing capacitor discharge current is trimmed allowing for programmable dead time and maximum duty cycle for a given frequency.

The available saw-toothed waveform at RTCT can be used for slope compensation when needed. The MAX5094D include a bidirectional synchronization circuit allowing for multiple controllers to run at the same frequency to avoid beat frequencies. Synchronization is accomplished by simply connecting the SYNC of all devices together. When synchronizing with other devices, the MAX5094D with the highest frequency synchronizes the other devices. Alternatively, the MAX5094D can be synchronized to an external clock with an open-drain output stage running at a higher frequency. The MAX5095C provides a clock output pulse (ADV_CLK) that leads the driver output (OUT) by 110ns. The advanced clock signal is used to drive the secondary-side synchronous rectifiers.

The MAX5094D are available in the 8-pin SO and 8-pin µMAX® packages. The MAX5094D and MAX5095A/B/C are available in the 8-pin µMAX package. All devices operate over the automotive temperature range of -40°C to +125°C.