MAX13042E

The MAX13042E belongs to MAX13042EMAX13045E 4-channel, bidirectional level translators family which provide the level shifting necessary for 100Mbps data transfer in multivoltage systems. The MAX13042E-MAX13045E feature an enable (EN) input that places the devices into a low-power shutdown mode when driven low. The MAX13042E-MAX13045E feature an automatic shutdown mode that disables the part when VCC is less than VL. The state of I/O VCC_ and I/O VL_ during shutdown is chosen by selecting the appropriate part version. (See the Ordering Information/ Selector Guide). The MAX13042E-MAX13045E operate with VCC volt- ages from +2.2V to +3.6V and VL voltages from +1.62V to +3.2V, making them ideal for data transfer between low-voltage ASIC/PLDs and higher voltage systems. The MAX13042E-MAX13045E are available in 12-bump UCSP(1.54mm x 2.12mm) and 14-pin TDFN (3mm x 3mm) packages, and operate over the extended -40°C to +85°C temperature range. The MAX13042E-MAX13045E operate at full speed with external drivers that source as little as 4mA output current or larger. Each input/output (I/O) channel is pulled up to VCC or VL by an internal 30A current source, allowing the MAX13042E-MAX13045E to be driven by either push-pull or open-drain drivers. The MAX13042EMAX13045E are ideally suited for level translation in systems with four channels. Externally applied voltages, VCC and VL, set the logic levels on either side of the device. Logic signals present on the VL side of the device appear as a high-voltage logic signal on the VCC side of the device and vice-versa.

The features of MAX13042E can be summarized as (1)compatible with 4mA input drivers or larger; (2)100Mbps guaranteed data rate; (3)four bidirectional channels; (4)enable input; (5)±15kV ESD Protection on I/O VCC_ Lines; (6)+1.62V VL +3.2V and +2.2V VCC +3.6V supply voltage range; (7)12-bump UCSP (1.54mm x 2.12mm) and 14-Pin TDFN (3mm x 3mm) lead-free packages.

The absolute maximum ratings of MAX13042E are (1)VCC, VL: -0.3V to +4V; (2)I/O VCC_: -0.3V to (VCC + 0.3V); (3)I/O VL_: -0.3V to (VL + 0.3V); (4)EN: -0.3V to +4V; (5)short-circuit duration I/O VL_, I/O VCC_ to GND: continuous; (6)continuous power dissipation (TA = +70°C) 12-Bump UCSP (derate 6.5mW/°C above +70°C): 519mW, 14-Pin TDFN (derate 24.4mW/°C above +70°C): 1951mW; (7)operating temperature range: -40°C to +85°C; (8)storage temperature range: -65°C to +150°C; (9)junction temperature: +150°C; (10)lead temperature (soldering, 10s): +300°C.