Features: High Input Impedance: Up to 256 Transceivers on the BusLow Power: ICC = 120mA Max with Driver Disabled ICC = 200mA Max with Driver Enabled, No Load1mA Quiescent Current in Shutdown ModeControlled Slew Rate Driver for Reduced EMI Single 5V Supply ESD Protection to ±10kV On Receiver Inputs...
LTC1487: Features: High Input Impedance: Up to 256 Transceivers on the BusLow Power: ICC = 120mA Max with Driver Disabled ICC = 200mA Max with Driver Enabled, No Load1mA Quiescent Current in Shutdown ModeCon...
SeekIC Buyer Protection PLUS - newly updated for 2013!
268 Transactions
All payment methods are secure and covered by SeekIC Buyer Protection PLUS.
Supply Voltage (VCC) ................................................. 12V
Control Input Voltage ..................... 0.5V to VCC + 0.5V
Driver Input Voltage ....................... 0.5V to VCC + 0.5V
Driver Output Voltage ............................................. ±14V
Receiver Input Voltage ........................................... ±14V
Receiver Output Voltage ................ 0.5V to VCC + 0.5V
Operating Temperature Range ............. 0°C £ TA £ 70°C
Lead Temperature (Soldering, 10 sec)................. 300°C
DescriptionThe LTC 1487 is an ultra-low power differential line transceiver designed with high impedance inputs allowing up 256 transceivers to share a single bus. It meets the requirements of RS485 and RS422. The LTC1487 features output drivers with controlled slew rate, decreasing the EMI radiated from the RS485 lines, and improving signal fidelity with misterminated lines. The CMOS design offers significant power savings without sacrificing ruggedness against overload or ESD damage. Typical quiescent current is only 80mA while operating and 1mA in shutdown.
The driver and receiver feature three-state outputs, with the driver outputs maintaining high impedance over the entire common-mode range. Excessive power dissipation caused by bus contention or faults is prevented by thermal shutdown circuit which forces the driver outputs into a high impedance state. The receiver has a fail-safe feature which guarantees a high output state when the inputs are left open. I/O pins are protected against multiple ESD strikes of over ±10kV using the Human Body Model.
The LTC1487 is fully specified over the commercial temperature range and is available in 8-pin DIP and SO packages.