LT1213

Slew Rate 12V/ms Typ
Gain-Bandwidth Product 28MHz Typ
Fast Settling to 0.01% 2V Step to 200mV
500ns Typ 10V Step to 1mV 1.1ms Typ
Excellent DC Precision in All Packages
   Input Offset Voltage 275mV Max Input
   Offset Voltage Drift 6mV/°C Max Input
   Offset Current 40nA Max Input Bias Current
   200nA Max Open-Loop Gain 1200V/mV Min
Single Supply Operation Input Voltage
   Range Includes Ground Output Swings to
   Ground While Sinking Current
Low Input Noise Voltage 10nV/ÖHz Typ
Low Input Noise Current 0.2pA/ÖHz Typ
Specified at 3.3V, 5V and ±15V
Large Output Drive Current 30mA Min
Low Supply Current per Amplifier 3.5mA Max
Dual in 8-Pin DIP and SO-8
Quad in 14-Pin DIP and NARROW SO-16

2.5V Full-Scale 12-Bit Systems VOS £ 0.45LSB
10V Full-Scale 16-Bit Systems VOS £ 1.8LSB
Active Filters
Photodiode Amplifiers
DAC Current-to-Voltage Amplifiers
Battery-Powered Systems

Total Supply Voltage (V + to V ) ...........................36V
Input Current ....................................................±15mA
Output Short-Circuit Duration (Note 1) ........Continuous
Operating Temperature Range
LT1213C/LT1214C ............................ . 40°C to 85°C
LT1213M ......................................... ..55°C to 125°C
Storage Temperature Range .............65°C to 150°C
Junction Temperature (Note 2)
Plastic Package (N8, S8, N, S) ........................ ....150°C
Ceramic Package (J8)...................................... ....175°C
Lead Temperature (Soldering, 10 sec).................300°C

The LT1213 is a dual, single supply precision op amp with a 28MHz gain-bandwidth product and a 12V/ms slew rate. The LT1214 is a quad version of the same amplifier. The DC precision of the LT1213/LT1214 eliminates trims in most systems while providing high frequency performance not usually found in single supply amplifiers.

The LT1213/LT1214 will operate on any supply greater than 2.5V and less than 36V total. These amplifiers are specified at single 3.3V, single 5V and ±15V supplies, and only require 2.7mA of quiescent supply current per amplifier. The inputs can be driven beyond the supplies without damage or phase reversal of the output. The minimum output drive is 30mA, ideal for driving low impedance loads.