Features: 3.3V Operation (5V tolerant)
LPC Interface
− Multiplexed Command, Address and Data Bus
− Serial IRQ Interface Compatible with Serialized IRQ
Support for PCI Systems
ACPI 1.0b/2.0 Compliant
Programmable Wake-up Event Interface
PC99a/PC2001 Compliant
General Purpose Input/Output Pins (13)
Fan Tachometer Inputs (2)
Green and Yellow Power LEDs
ISA Plug-and-Play Compatible Register Set
Motherboard GLUE Logic
− 5V Reference Generation
− 5V Standby Reference Generation
− IDE Reset/Buffered PCI Reset Outputs
− Power OK Signal Generation
− Power Sequencing
− Power Supply Turn On Circuitry
− Resume Reset Signal Generation
− Hard Drive Front Panel LED
− Voltage Translation for DDC to VGA Monitor
− SMBus Isolation Circuitry
− CNR Dynamic Down Control
2.88MB Super I/O Floppy Disk Controller
− Licensed CMOS 765B Floppy Disk Controller
− Software and Register Compatible with SMSC's
Proprietary 82077AA Compatible Core
− Supports One Floppy Drive
− Configurable Open Drain/Push-Pull Output Drivers
− Supports Vertical Recording Format
16-Byte Data FIFO
− 100% IBM Compatibility
− Detects All Overrun and Underrun Conditions
Sophisticated Power Control Circuitry (PCC)
Including Multiple Powerdown Modes for
Reduced Power Consumption
− DMA Enable Logic
− Data Rate and Drive Control Registers
480 Address, Up to Eight IRQ and Three DMA
Options
Enhanced Digital Data Separator
− 2 Mbps, 1 Mbps, 500 Kbps, 300 Kbps, 250 Kbps
Data Rates
− Programmable Precompensation Modes
Keyboard Controller
− 8042 Software Compatible
− 8 Bit Microcomputer
− 2k Bytes of Program ROM
− 256 Bytes of Data RAM
− Four Open Drain Outputs Dedicated for
Keyboard/Mouse Interface
− Asynchronous Access to Two Data Registers and
One Status Register
− Supports Interrupt and Polling Access
− 8 Bit Counter Timer
− Port 92 Support
− Fast Gate A20 and KRESET Outputs
Serial Ports
− Two Full Function Serial Ports
− High Speed 16C550A Compatible UART with
Send/Receive 16-Byte FIFOs
− Supports 230k and 460k Baud
− Programmable Baud Rate Generator
− Modem Control Circuitry
− 480 Address and 15 IRQ Options
Infrared Port
− Multiprotocol Infrared Interface
− 32-Byte Data FIFO
− IrDA 1.0 Compliant
− SHARP ASK IR
− HP-SIR
− 480 Address, Up to 15 IRQ and Three DMA Options
Multi-Mode Parallel Port with ChiProtect
− Standard Mode IBM PC/XT, PC/AT, and PS/2
Compatible Bi-directional Parallel Port
− Enhanced Parallel Port (EPP) Compatible - EPP 1.7
and EPP 1.9 (IEEE 1284 Compliant)
− IEEE 1284 Compliant Enhanced Capabilities Port
(ECP)
− ChiProtect Circuitry for Protection
− 960 Address, Up to 15 IRQ and Three DMA Options
Interrupt Generating Registers
− Registers Generate IRQ1 IRQ15 on Serial IRQ
Interface.
XOR-Chain Board Test
128 Pin QFP Packages, 3.2 mm Footprint; green,
lead-free also availablePinout
SpecificationsMaximum 3.3 Supply ............................................................................................................................ +4.1V
Maximum 5V Supply ............................................................................................................................. +6.0V
Voltage on any 3.3V pin, with respect to Ground......................................................................... -0.5 to 5.5V
Voltage on any 5V pin, with respect to Ground............................................................................ -0.5 to 5.5V
Operating Temperature Range ..................................................................................................0oC to +70oC
Storage Temperature Range .................................................................................................. -55o to +150oC
Lead Temperature Range (lead-free, P/N LPC47N182-NW)..................Refer to JEDEC Spec. J-STD-020B
Lead Temperature Range (leaded, P/N LPC47N182-NR) ........................ Refer to JEDEC Spec. J-STD-020
Description
The LPC47M182* is a 3.3V (5V tolerant) PC99a/PC2001 compliant Advanced I/O controller for Desktop PCs. The device, which implements the Low Pin Count (LPC) interface, includes I/O functionality as well as Motherboard GLUE logic into a 128-pin package. This is space saving solution on the motherboard resulting in lower cost. The LPC47M182 also provides 13 general purpose pins, which offer flexibility to the system designer, and two Fan Tachometer Inputs.
The LPC47M182's LPC interface supports LPC I/O and DMA cycles. The LPC47M182 includes complete legacy I/O: a keyboard interface; SMSC's true CMOS 765B floppy disk controller with advanced digital data separator; two 16C550A compatible UARTs; one Multi-Mode parallel port including ChiProtect circuitry plus EPP and ECP.
The true CMOS 765B core provides 100% compatibility with IBM PC/XT and PC/AT architectures, in addition, it provides data overflow and underflow protection. The SMSC's patented advanced digital data separator allows for ease of testing and use. The parallel port is compatible with IBM PC/AT architecture, as well as IEEE 1284 EPP and ECP. The LPC47M182 incorporates sophisticated power control circuitry (PCC) which includes support for keyboard and mouse wake up events as well as PME support.
The PCC supports multiple low power-down modes. The LPC47M182 is ACPI 1.0b/2.0 compatible. The Motherboard GLUE logic includes various power management logic; including generation of nRSMRST, Power OK signal generation, 5V main and standby reference generation. There are also three LEDs to indicate power status and hard drive activity. The translation circuit converts 3.3V signals to 5V signals. Also included is SMBus main power well to resume power well isolation circuitry. The LPC47M182 supports the ISA Plug-and-Play Standard register set (Version 1.0a).
The I/O Address, DMA Channel and hardware IRQ of each logical device in the LPC47M182 may be reprogrammed through the internal configuration registers. There are up to 480 (960 for Parallel Port) I/O address location options, a Serialized IRQ interface, and three DMA channels. On chip, Interrupt Generating Registers enable external software to generate IRQ1 through IRQ15 on the Serial IRQ Interface.
The LPC47M182's Enhanced Digital Data Separator does not require any external filter components and is therefore easy to use and offers lower system costs and reduced board area. The LPC47M182 is
LPC47M182 Data Sheet
