Features: `Internal power-on reset` Active low reset`Internal precision oscillator` Variable dim rates (from 6.25 ms to 1.6s; 160 Hz0.625 Hz)Application· Customized flashing LED lights for cellular phones· Portable Applications· Digital Cameras· Indicator Lamps· General purpose I/O expander· ToysS...
LP3944: Features: `Internal power-on reset` Active low reset`Internal precision oscillator` Variable dim rates (from 6.25 ms to 1.6s; 160 Hz0.625 Hz)Application· Customized flashing LED lights for cellular ...
SeekIC Buyer Protection PLUS - newly updated for 2013!
268 Transactions
All payment methods are secure and covered by SeekIC Buyer Protection PLUS.
Regulated LEDs | 8 |
LED Configuration | Parallel |
Current Matching | 0.30% |
Boost Type | Inductive |
Switching Frequency | Undefined kHz |
Switching Type | Fixed Freq |
Total LED Current | Undefined mA |
Efficiency (peak) | Undefined % |
Boost Voltage | Regulated |
Supply Current | Undefined mA |
Input Min Voltage | 2.3 Volt |
Input Max Voltage | 5.5 Volt |
OutputMax Voltage | Undefined Volt |
PWM BrightCtrl | Yes |
Analog-V BrightCtrl | No |
Ambient Light Compensation | No |
RGB-LED | Yes |
Temperature Min | -40 deg C |
Temperature Max | 85 deg C |
RegType | Lighting Management Unit |
PowerWise | Yes |
View Using Catalog |
LP3944 is an integrated device capable of independently driving 8 LEDs. This device also contains an internal precision oscillator that provides all the necessary timing required for driving each LED. Two prescaler registers along with two PWM registers provide a versatile duty cycle control. The
LP3944 contains the ability to dim LEDs in SMBUS/I2C applications where it is required to cut down on bus traffic. Traditionally, to dim LEDs using a serial shift register such as 74LS594/5 would require a large amount of traffic to be on the serial bus. LP3944 instead requires only the setup of the frequency and duty cycle for each output pin. From then on, only a single command from the host is required to turn each individual open drain output ON, OFF, or to cycle a programmed frequency and duty cycle. Maximum output sink current is 25 mA per pin and 200 mA per package. Any ports not used for controlling the LEDs can be used for general purpose input/output expansion.