Features: ` 3.5dB Typical Noise Figure` 12.5dB Typical Gain` 12dBm Saturated Output Power` 12dB Input/Output Return Loss Typical` 0.5-6GHz Frequency Bandwidth` +8 Volts Single Bias Supply` DC Decoupled RF Input and Output` Chip Size : 1.62mmX1.62mm (.064 X.064 )` Chip Thickness : 100mm` Pad Dimens...
LMA110B: Features: ` 3.5dB Typical Noise Figure` 12.5dB Typical Gain` 12dBm Saturated Output Power` 12dB Input/Output Return Loss Typical` 0.5-6GHz Frequency Bandwidth` +8 Volts Single Bias Supply` DC Decoup...
SeekIC Buyer Protection PLUS - newly updated for 2013!
268 Transactions
All payment methods are secure and covered by SeekIC Buyer Protection PLUS.
Features: `20 ns Multiply-Accumulate Time`Low Power CMOS Technology`Replaces Fairchild TDC1009/ TM...
Features: `20 ns Multiply-Accumulate Time`Replaces Fairchild TMC2210, Cypress CY7C510, IDT 7210L, ...
Symbol |
Parameter /Conditions |
Min. |
Max. |
Units |
Vdd |
Drain Supply Voltage |
13 |
Volts | |
Idd |
Total Drain Current |
110 |
mA | |
Pin |
RF Input Power |
24 |
dBm | |
Pt |
Power Dissipation |
1.5 |
W | |
Tch |
Operating Channel Temperature |
150 |
||
Tstg |
Storage Temperature |
-65 |
165 |
|
Tmax. |
Max. Assembly Temp. (1 min. max.) |
300 |
Notes:
` Operating conditions that exceed the Absolute Maximum Ratings could result in permanent damage to the device.
` Recommended Continuous Operating Limits should be observed for reliable device operation.
` Power Dissipation defined as: PTOT = (PDC + PIN) POUT, where
PDC: DC Bias Power
PIN: RF Input Power
POUT: RF Output Power
` This GaAs MMIC is susceptible to damage from Electrostatic Discharge. Proper precautions should be used when handling these devices.
The Filtronic LMA110B is a GaAs monolithic distributive amplifier which operates from 0.5 to 8 GHz. This amplifier produces a typical gain of 12.5dB with a noise figure of 3.5dB. The LMA110B is suitable for wide-band low noise gain block, EW and commercial PCN applications. DC decoupled input and output RF port. Ground is provided to the circuitry through vias to the backside metallization.