Features: 90mW (typ.) High-Side MOSFET Switch500mA Continuous Current per Port7 ms Fault Flag Delay Filters Hot-Plug Events Industry Standard Pin OrderShort Circuit Protection with Power-Saving Current FoldbackThermal Shutdown Protection Undervoltage Lockout Recognized by UL and Nemko Input Volta...
LM3543: Features: 90mW (typ.) High-Side MOSFET Switch500mA Continuous Current per Port7 ms Fault Flag Delay Filters Hot-Plug Events Industry Standard Pin OrderShort Circuit Protection with Power-Saving Cur...
SeekIC Buyer Protection PLUS - newly updated for 2013!
268 Transactions
All payment methods are secure and covered by SeekIC Buyer Protection PLUS.
Voltage at INX and OUTX pins Voltage at ENX(ENX) and FLAGX pins Power Dissipation (Note 2) Maximum Junction Temperature Storage Temperature Range Lead Temperature Range (Soldering, 5 sec.) ESD Rating (Note 3) |
−0.3V to 6V −0.3V to 5.5V Internally Limited 150°C −65°C to 150°C 260°C 2 kV |
The LM3543 is a triple high-side power switch that is an excellent choice for use in Root, Self-Powered and Bus-Powered USB (Universal Serial Bus) Hubs. Independent port enables, flag signals to alert USB controllers of error conditions, controlled start-up in hot-plug events, and short circuit protection all satisfy USB requirements. The LM3543 accepts input voltages between 2.7V and 5.5V.
The Enable logic inputs, available in active-high and active-low versions, can be powered off any voltage in the 2.7V to 5.5V range.
The LM3543 limits the continuous current through a single port to 1.25A (max.) when it is shorted to ground. The low on-state resistance of the LM3543 switches ensures the LM3543 will satisfy USB voltage drop requirements, even when current through a switch reaches 500 mA. Thus, High-Powered USB Functions, Low-Powered USB Functions, and Bus-Powered USB Hubs can all be powered off a Root or Self-Powered USB Hub containing the LM3543.
Added features of the LM3543 include current foldback to reduce power consumption in current overload conditions, thermal shutdown to prevent device failure caused by high-current overheating, and undervoltage lockout to keep switches from operating if the input voltage is below acceptable levels.