Features: • Operates from single 3V supply (LM311B)• Maximum input bias current: 150nA (LM311-250nA)• Maximum offset current: 20nA (LM311-50nA)• Differential input voltage range: ±30V• Power consumption: 135mW at ±15V• High sensitivity-200V/mV• Zero crossi...
LM311B: Features: • Operates from single 3V supply (LM311B)• Maximum input bias current: 150nA (LM311-250nA)• Maximum offset current: 20nA (LM311-50nA)• Differential input voltage ra...
SeekIC Buyer Protection PLUS - newly updated for 2013!
268 Transactions
All payment methods are secure and covered by SeekIC Buyer Protection PLUS.
SYMBOL |
PARAMETER |
RATING |
UNIT |
VS |
Total supply voltage |
36 |
V |
Output to negative supply voltage: LM111/LM211 LM311/LM311B |
50 40 |
V V | |
Ground to negative supply voltage |
30 |
V | |
Differential input voltage |
±30 |
V | |
VIN |
Input voltage1 |
±15 |
V |
PD MAX |
Maximum power dissipation,TA=25°C (still-air)2 F package N package D packageOutput short-circuit duration |
810 1190 780 |
mW mW mW |
I |
Output short-circuit duration |
10 |
sec |
TA |
Operating ambient temperature range LM111 LM211 LM311/LM311B |
-55to+125 -25to+85 0to+70 |
°C °C °C |
TSTG |
Storage temperature range |
-65to+150 |
°C |
TSOLD |
Lead soldering temperature (10sec max) |
300 |
°C |
NOTES:
1. This rating applies for ±15V supplies. The positive input voltage limit is 30V above the negative supply. The negative input voltage limit is equal to the negative supply voltage or 30V below the positive supply, whichever is less.
2. Derate above 25°C, at the following rates: F package at 6.4mW/°C; N package at 9.5mW/°C; D package at 6.2m/W°C
The LM311B series are voltage comparators that have input currents approximately a hundred times lower than devices like the mA710.They are designed to operate over a wider range of supply voltages;from standard ±15V op amp supplies down to a single 3V supply.Their output is compatible with RTL, DTL, and TTL as well as MOS circuits. Further, they can drive lamps or relays, switching voltages up to 50V at currents as high as 50mA.
Both the inputs and the outputs of the LM311B series can be isolated from system ground, and the output can drive loads referred to ground, the positive supply, or the negative supply. Offset balancing and strobe capability are provided and outputs can be wire-ORed.
Although slower than the mA710 (200ns response time vs 40ns), the devices are also much less prone to spurious oscillations. The LM311B series has the same pin configuration as the A710 series