Solid State Relays Normally Open Form 2A 15V
LH1514AAC: Solid State Relays Normally Open Form 2A 15V
SeekIC Buyer Protection PLUS - newly updated for 2013!
268 Transactions
All payment methods are secure and covered by SeekIC Buyer Protection PLUS.
Product Type : | PCB Mount | Mounting Style : | SMD/SMT |
Load Voltage Rating : | 15 V | Load Current Rating : | 0.15 A |
Contact Form : | 2 Form A (DPST-NO) | Output Device : | MOSFET |
Package / Case : | SMD-8 |
• Load Voltage, 15 V
• Load Current, 150 mA
• Switching Capability up to 50 MHz
• Blocking Capability Dependent upon Signal dv/dt
• Low and Typical RON5.0
• 1.0 ms Actuation Time
• Low Power Consumption
• 3750 VRMS I/O Isolation
• Balanced Switching
• Linear AC/DC Operation
• Clean, Bounce-free Switching
• Surface-mountable
Absolute Maximum Ratings, T A =25
Stresses in excess of the Absolute Maximum Ratings can cause permanent damage to the device. These are absolute stress ratings only. Functional operation of the device is not implied at these or any other conditions in excess of those given in the operational sections of the data sheet. Exposure to maximum rating conditions for extended periods can adversely affect device reliability.
Ambient Operating Temperature Range, T A .......40 ° to +85
Storage Temperature Range, T stg ....................40 ° to +150
Pin Soldering Temperature, t=10 s max, T S ..........................260
Input/Output Isolation Voltage, V ISO .................................3750 V
RMS LED Input Ratings:
Continuous Forward Current, I F .......................................50 mA
Reverse Voltage, I R 10 A, V R ..................................... 10 V
Output Operation:
dc or Peak ac Load Voltage, I L 1.0 A, V L .....................15 V
Continuous dc Load Current, I L
Each Pole, Two Poles Operating Simultaneously .............150 mA
Power Dissipation, P DISS ...................................................600 mW
The LH1514AAC is a DPST normally open (2 Form A) SSR that can be used in balanced high-frequency applications like T1 switching. With its low ON-resistance and high actuation rate, the LH1514 is also very attractive as a general-purpose 2 Form A SSR for balanced signals.
The LH1514AAC are constructed using a GaAlAs LED for actuation control and an integrated monolithic die for the switch output. The die, fabricated in a dielectrically isolated Smart Power BiCMOS, is comprised of a photodiode array, switch control circuitry, and NMOS switches.
In balanced switching applications, internal circuitry shunts high-frequency signals between two poles when the SSR is off. This balanced T termination technique provides high isolation for the load.