LH1513AB

Control Voltage Range :
Product Type : PCB Mount
Output Device : MOSFET
Mounting Style : Through Hole
Contact Form : 2 Form A (DPST-NO)
Load Voltage Rating : 200 V
Load Current Rating : 0.2 A
Package / Case : PDIP-8


Features:

• Current Limit Protection
• l/O Isolation, 5300 V_RMS
• Typical R_ON10
• Load Voltage 200 V
• Load Current 140 mA
• High Surge Capability
• Linear, AC/DC Operation
• Clean Bounce Free Switching
• Low Power Consumption
• High Reliability Monolithic Receptor
• SMD Lead Available on Tape and Reel

Application

• General Telecom Switching
On/off Hook Control
Ring Delay
Dial Pulse
Ground Start
Ground Fault Protection
• Instrumentation
• Industrial Controls




Specifications

Absolute Maximum Ratings, T A =25
Stresses in excess of the Absolute Maximum Ratings can cause permanent damage to the device. These are absolute stress ratings only. Functional operation of the device is not implied at these or any other conditions in excess of those given in the operational sections of the data sheet. Exposure to maximum rating conditions for extended periods can adversely affect device reliability.
Ambient Temperature Range (TA) ...................................40 to +85
Storage Temperature Range (T_stg) ...............................40 to +150
Pin Soldering Temperature (t=10 s max) (TS) ............................. 260
Input/Output Isolation Voltage (V_ISO) ................................ 5300 VRMS
Pole-to-Pole Isolation Voltage (S1 to S2).....................................500 V
LED Continuous Forward Current (I_F) .........................................50 mA
LED Reverse Voltage (I_R10A) (V_R)...........................................8.0 V
DC or Peak AC Load Voltage (I_L50A) (V_L) ..............................200 V
Continuous DC Load Current (I_L)
One Pole Operating...............................................................200 mA
Two Poles Operating ............................................................140 mA
Peak Load Current (t=100 ms) (single shot) (I_P) ................................ †
Output Power Dissipation (continuous) (P_DISS)........................600 mW
† Refer to Current Limit Performance Application Note for a discussion on relay operation during transient currents.

Description

2 Form A Solid State Relay

The LH1513AB relays are DPST normally open switches (2 Form A) that can replace electromechanical relays in many applications. The relays are constructed using a GaAlAs LED for actuation control and an integrated monolithic die for the switch output. The die, fabricated in a high-voltage dielectrically isolated technology, is comprised of a photodiode array, switch control circuity, and DMOS switches. In addition, LH1513AB employ current-limiting circuity, enabling them to pass FCC 68.302 and other regulatory voltage surge requirements when overvoltage protection is provided.