IRF7319PBF

Mounting Style : SMD/SMT
Drain-Source Breakdown Voltage : 30 V
Maximum Operating Temperature : + 150 C
Packaging : Tube
Gate-Source Breakdown Voltage : 20 V
Package / Case : SOIC-8
Transistor Polarity : N and P-Channel
Configuration : Dual Dual Drain
Continuous Drain Current : 6.5 A
Resistance Drain-Source RDS (on) : 46 mOhms


Features:






Specifications






Description

      The IRF7319PBF has the following features including generation V technology;ultra low on-resistance;dual N and P channel mosfet;surface mount;fully avalanche rated;lead-free.
      Both the IRF7319PBF and PT6715 series ISRs are non-pro- grammable versions of the PT6700 Excalibur™ family of converters. These regulators have a fixed output voltage, which may be adjusted higher or lower than the factory trimmed pre-set voltage using a single external resistor. Table 1 gives the allowable adjustment range for each model as Va (min) and Va (max). Adjust Up:An increase in the output voltage is obtained by adding a resistor R2, between pin 1 (Vo adjust) and pin 7 (CRemote Sense). The IRF7319PBFB is a monolithic integrated circuit fabricated in Metal Oxide Semiconductor technology available in DIP and SOP packages. The IRF7319PBFB is a dual 1 of 4 decoder/ demultiplexer. Each decoder has two select inputs (A and B), an Enable input (E), and four mutually.
      The STTH5R06, which is using ST Turbo 2 600V technology, is specially suited as boost diode in continuous mode power factor corrections and hard switching conditions. This device is also intended for use as a free wheeling diode in power supplies and other power switching applications. Remote On/Off: This is an open-collector (open-drain) negative logic input that enables the module output. The input is referenced to CVin. Applying a low-level ground signal to this pin disables the modules outputs. A high impedance enables the modules outputs. If not used the pin should be left unconnected.  If the connection between module and antenna does not form part of the antenna itself, it should be made using 50 microstrip line or coax or a combination of both. It is desirable (but not essential) to fill all unused PCB area around the module with ground plane.
      At present there is not too much information about this model.If you are willing to find more  about IRF7319PBF, please pay attention to our web! We will promptly update the relevant information.

Parameters:

Technical/Catalog Information	IRF7319PBF
Vendor	International Rectifier
Category	Discrete Semiconductor Products
Mounting Type	Surface Mount
FET Polarity	N and P-Channel
Drain to Source Voltage (Vdss)	30V
Current - Continuous Drain (Id) @ 25° C	6.5A, 4.9A
Rds On (Max) @ Id, Vgs	29 mOhm @ 5.8A, 10V
Input Capacitance (Ciss) @ Vds	650pF @ 25V
Power - Max	2W
Packaging	Tube
Gate Charge (Qg) @ Vgs	33nC @ 10V
Package / Case	8-SOIC (3.9mm Width)
FET Feature	Standard
Drawing Number	*
Lead Free Status	Lead Free
RoHS Status	RoHS Compliant
Other Names	IRF7319PBF IRF7319PBF