Features: · PWM Current Limit for Short Circuit Protection· Over-Temperature Protection· Active Output Negative Clamp· Reverse Battery Protection for Logic Circuit· Broken Ground Protection· Short to VCCProtection· Low Noise Charge Pump· Sleep Mode Supply Current· 4kV ESD Protection On All Pins· L...
IR6320G: Features: · PWM Current Limit for Short Circuit Protection· Over-Temperature Protection· Active Output Negative Clamp· Reverse Battery Protection for Logic Circuit· Broken Ground Protection· Short t...
SeekIC Buyer Protection PLUS - newly updated for 2013!
268 Transactions
All payment methods are secure and covered by SeekIC Buyer Protection PLUS.
Minimum | Maximum | Units | Test Conditions | |||
Vcc | Supply Voltage | Permanent | -0.3 | 50 | V | Pin 3 to Pin 1 (1), for 10 seconds |
Reverse | -16 | - | ||||
Voffset | Logic to Power Ground Offset | Vcc -50 | Vcc +0.3 | |||
Vin | Input Voltage | -0.3 | 7 | |||
Iin | Input Current | - | 10 | mA | ||
Vout | Output Voltage | Vcc -50 | Vcc +0.3 | V | ||
Iout | Output Current | - | Self-limited | |||
Vdg | Diagnostic Output Voltage | -0.3 | 7 | V | ||
Idg | Diagnostic Output Current | - | 10 | mA | ||
Eav | Repetitive Avalanche Energy | - | 100 | mJ | I = 2A (2) | |
ESD1 | Electrostatic Discharge(Human Body Model) | - | 4000 | V | C = 100 pF, R = 1500 | |
ESD2 | Electrostatic Discharge (Machine Model) | - | 500 | V | C = 200 pF, R = 0 | |
PD | Power Dissipation | - | 2 | W | Tcase=25 | |
TJop | Operating Junction Temperature Range | -40 | 150 | |||
TStg | Storage Temperature Range | -40 | 150 |
The IR6320G is a monolithic HIGH SIDE SWITCH with built in short circuit, over- temperature, ESD, inductive load turn off capability and diagnostic feedback.
The on-chip protection circuit goes into PWM mode, limiting the average current during short circuit if the drain current exceeds 10A. The protection circuit latches off the high side switch if the junction temperature exceeds 170 and latches on after the junction temperature falls by 10. The Vcc (drain) to OUT (source) voltage is actively clamped at 55V, improving its performance during turn off with inductive loads.
The on-chip charge pump high side driver stage of the IR6320G is floating and referenced to the source of the power MOSFET. Thus the logic to power ground isolation can be as high as 50V.
This allows operation with larger offset as well as controlling the switch during load energy recirculation or regeneration.
A diagnostic pin of the IR6320G is provided for status feedback of short circuit, over temperature and open load detection.