PinoutSpecifications Rating Simbol Value Unit Pin1 Positive Current (Continious/Pulse) I1+ 150 to 500 mA Pin1 Negative Current (Continious/Pulse) I1- -35 to -500 mA Current (Continious/Pulse) I2 ±350 to ±1900 mA Current (Continious/Pulse) I...
IL33193: PinoutSpecifications Rating Simbol Value Unit Pin1 Positive Current (Continious/Pulse) I1+ 150 to 500 mA Pin1 Negative Current (Continious/Pulse) I1- -35 to -500...
SeekIC Buyer Protection PLUS - newly updated for 2013!
268 Transactions
All payment methods are secure and covered by SeekIC Buyer Protection PLUS.
Rating |
Simbol |
Value |
Unit |
Pin1 Positive Current (Continious/Pulse) |
I1+ |
150 to 500 |
mA |
Pin1 Negative Current (Continious/Pulse) |
I1- |
-35 to -500 |
mA |
Current (Continious/Pulse) |
I2 |
±350 to ±1900 |
mA |
Current (Continious/Pulse) |
I3 |
±300 to ±1400 |
mA |
Current (Continious/Pulse) |
I8 |
±25 to ±50 |
mA |
ESD(Aii Pins Except Pin4 for Negative Pulse) |
VESD |
±2000 |
V |
ESD(Pin 4 Negative Pulse) |
VESD4- |
-1000 |
V |
Jinction Temperature |
TJ |
150 |
|
Operation Ambient Temperature Range |
TA |
-40 to +125 |
|
Storage Temperature Range |
TSTG |
-65 to +150 |
The IL33193 is a new generation industry standard UAA1041 "Flasher".It has been developed for enhanced EMI sensitivity, system reliability, and improved wiring simplification. The IL33193 is pin compatible with the UAA1041 and UAA1041B in the standard application configuration as shown in Figure 9, without lamp short circuit detection and using a 20 m shunt resistor. The IL33193 has a standby mode of operation requiring very low standby supply current and can be directly connected to the vehicle's battery. It includes an RF filter on the Fault detection pin (Pin 7) for EMI purposes. Fault detection thresholds are reduced relative to those of the IL33193, allowing a lower shunt resistance value (20 mW) to be used.
• Pin Compatible with the UAA1041
• Defective Lamp Detection Threshold
• RF Filter for EMI Purposes
• Load Dump Protection
• Double Battery Capability for Jump Start