Features: • 15 dB RF-IF Conversion Gain from 0.05 - 5 GHz• IF Output from DC to 2 GHz• IF Output PldB up to +12 dBm• Single Polarity Bias Supply: VCC = 7 to 13 V• Load-Insensitive Performance• Conversion Gain Flat Over Temperature• Low LO Power Requirement...
IAM-82028: Features: • 15 dB RF-IF Conversion Gain from 0.05 - 5 GHz• IF Output from DC to 2 GHz• IF Output PldB up to +12 dBm• Single Polarity Bias Supply: VCC = 7 to 13 V• Load-...
SeekIC Buyer Protection PLUS - newly updated for 2013!
268 Transactions
All payment methods are secure and covered by SeekIC Buyer Protection PLUS.
Parameter | Absolute Maximum[1] | |
Device Voltage | V | 15 |
Total Device Dissipation[2][3] | mW | 1200 |
RF Input Power | dBm | +14 |
LO Input Power | dBm | +14 |
Junction Temperature | °C | 200 |
Storage Temperature | °C | -65 to +150 |
Notes:
1. Permanent damage may occur if any of these limits are exceeded.
2. TCASE = 25°C.
3. Derate at 22.2 mW/°C for TC >146°C.
4. See MEASUREMENTS section "'Thermal Resistance" in
Communications Components Catalog, for more information.
The IAM-82028 is a complete moderate-power double-balanced active mixer housed in a miniature ceramic hermetic surface mount package. It is designed for narrow or wide bandwidth commercial, industrial and military applications having RF inputs up to 5 GHz and IF outputs from DC to 2 GHz.
Operation of the IAM-82028 at RF and LO frequencies less than 50 MHz can be achieved using optional external capacitors to ground. The IAM-82028 is particularly well suited for applications that require load-insensitive conversion gain and good spurious signal suppression and moderate dynamic range with minimum LO power. Typical applications include frequency downconversion, modulation, demodulation and phase detection for fiber-optic, GPS satellite navigation, mobile radio, and communications receivers.
The IAM IAM-82028 series of Gilbert multiplier-based frequency converters is fabricated using HP's 10 GHz fT, 25 GHz fMAX ISOSATTM-I silicon bipolar process which uses nitride self-alignment, submicrometer lithography, trench isolation, ion implantation, gold metallization and polyimide inter-metal dielectric and scratch protection to achieve excellent performance, uniformity and reliability.