HS-26C31RH

Features:

• Electrically Screened to SMD # 5962-96663
• QML Qualified per MIL-PRF-38535 Requirements
• 1.2 Micron Radiation Hardened CMOS
- Total Dose Up to . . . . . . . . . . . . . . . . . . . . 300kRAD(Si)
- Dose Rate Upset . . . . . . . > 1x109 RAD/s (20ns Pulse)
• Latchup Free
• EIA RS-422 Compatible Outputs (Except for IOS)
• CMOS Inputs
• High Impedance Outputs when Disabled or Powered Down
• Low Power Dissipation . . . . . . . . . 2.75mW Standby (Max)
• Single 5V Supply
• Low Output Impedance . . . . . . . . . . . . . . . . . 10W or Less
• Full -55 to 125oC Military Temperature Range




Pinout






Description

The Intersil HS-26C31RH is a quad differential line driver designed for digital data transmission over balanced lines and meets the requirements of EIA standard RS-422. Radiation hardened CMOS processing assures low power consumption, high speed, and reliable operation in the most severe radiation environments. The HS-26C31RH accepts CMOS signal levels and converts them to RS-422 compatible outputs. This circuit uses special outputs that enable the drivers to power down without loading down the bus. Enable and disable pins allow several devices to be connected to the same data source and addressed independently. Specifications for Rad Hard QML devices are controlled by the Defense Supply Center in Columbus (DSCC). The SMD numbers listed here must be used when ordering. Detailed Electrical Specifications for these devices are contained in SMD 5962-96663. A hot-link is provided on our homepage for downloading. http://www.intersil.com/