Features: Access time : 55,70, 90 and 120ns High-density 2MByte design High-reliability, low-power design Single + 5V ± 0.5V power supplyEasy memory expansionAll inputs and outputs are TTL- compatible FR4-PCB designLow profile 72-pin SIMM Minimum 1,000,000 write/erase cycle Sector erases architect...
HMF51232M4G: Features: Access time : 55,70, 90 and 120ns High-density 2MByte design High-reliability, low-power design Single + 5V ± 0.5V power supplyEasy memory expansionAll inputs and outputs are TTL- compatib...
SeekIC Buyer Protection PLUS - newly updated for 2013!
268 Transactions
All payment methods are secure and covered by SeekIC Buyer Protection PLUS.
PinoutDescriptionThe HMF51232J4 is a high-speed flash read only memory (FROM) module containing 52...
PinoutDescriptionThe HMF51232J4V is a high-speed flash read only memory (FROM) module containing 5...
Features: Access time : 55,70, 90 and 120ns High-density 2MByte design High-reliability, low-powe...
PARAMETER | SYMBOL | RATING |
Voltage with respect to ground all other pins | VIN,OUT | -2.0V to +7.0V |
Voltage with respect to ground Vcc | VCC | -2.0V to +7.0V |
Storage Temperature | TSTG | -65 to +125 |
Operating Temperature | TA | 55 to +125 |
The HMF51232M4G is a high-speed flash read only memory (FROM) module containing 524,288 words organized in a x32bit configuration. The module consists of four 512Kx 8 FROM mounted on a 72-pin, single-sided, FR4-printed circuit board.Commands are written to the command register using standard microprocessor write timings.
Register contents serve as input to an internal state-machine, which controls the erase and programming circuitry. Write cycles also internally latch addresses and data needed for the programming and erase operations. Reading data out of the device HMF51232M4G is similar to reading from 12.0V flash or EPROM devices.
Four chip enable inputs, (/CE_UU1, /CE_UM1, /CE_LM1, /CE_LL1) are used to enable the module HMF51232M4G's 4 bytes independently.
Output enable (/OE) and write enable (/WE) can set the memory input and output.
When FROM module is disable condition, the module HMF51232M4G is becoming power standby mode, system designer can get low-power
design.
All module HMF51232M4G components may be powered from a single +5V DC power supply and all inputs and outputs are TTL-compatible.