HMF1M32M8P

Stresses greater than those listed under " Absolute Maximum Ratings" may cause permanent damage to the device.
This is a stress rating only and functional operation of the device at these or any other conditions ab ove those indicated in the operating section of this specification is not implied. Exposure to absolute maximum rating conditions for extended periods may affect reliability.

The HMF1M32M8P is a high-speed flash read only memory (FROM) module containing 1,048,576 words organized in a x32bit configuration. The module consists of eight 512K x 8 FROM mounted on a 72 -pin, single-sided, FR4-printed circuit board. Commands are written to the command register using standard microprocessor write timings.

Register contents serve as input to an internal state-machine, which controls the erase and programming circuitry. Write cycles also internally latch addresses and data needed for the programming and erase operations. Reading data out of the
device HMF1M32M8P is similar to reading from 12.0V flash or EPROM devices.

Eight chip enable inputs, (/CE_UU1, /CE_UM1, /CE_LM1, /CE_LL1, /CE_UU2, /CE_UM2, /CE_LM2, /CE_LL2) are used to enable the module HMF1M32M8P's 4 bytes independently. Output enable (/OE) and write enable (/WE) can set the memory input and output..When FROM module is disable condition the module is becoming power standby mode, system designer can get low - power design. All module components may be powered from a single +5V DC power supply and all inputs and outputs are
TTL-compatible.