HCPL-653K

Maximum Reverse Diode Voltage :
Packaging :
Maximum Input Diode Current : 20 mA
Maximum Forward Diode Voltage : 1.9 V
Minimum Operating Temperature : - 55 C
Maximum Operating Temperature : + 125 C
Maximum Power Dissipation : 200 mW
Current Transfer Ratio : 20 %
Maximum Baud Rate : 400 KBps
Package / Case : LCCC-20


Description

The HCPL-653K is a Class K two channel hermetically sealed optocoupler in a 20 pad leadless ceramic chip carrier with solder dipped pads and the highest level of reliability. The solder contains lead.
The HCPL-653K is capable of operation and storage over the full military temp range and may also be purchased as either commercial grade, MIL-PRF-38534 Class Level H, or from the DSCC SMD 5962-87679. The HCPL-653K is manufactured and tested on a MIL-PRF-38534 certified line and included in the DSCC Qualified Manufacturers List QML-38534 for Hybrid Microcircuits.
Each HCPL-653K channel contains a GaAsP LED which is optically coupled to an integrated photon detector. Separate connections for the photodiodes and output transistor collectors improve the speed up to a hundred times that of a conventional phototransistor coupler by reducing the base-collector capacitance.
The HCPL-653K is suitable for wide bandwidth analog applications, as well as for interfacing TTL to LSTTL or CMOS. Current Transfer Ratio (CTR) is 9% min at IF = 16mA. The 18V Vcc capability will enable the designer to interface any TTL family to CMOS. The availability of the base lead allows optimized gain/bandwidth adjustment in analog applications. The shallow depth of the IC photodiode provides better radiation immunity than conventional phototransistor couplers.
This HCPL-653K is also available with the transistor base node connected to improve common mode immunity and ESD susceptibility. In addition, higher CTR minimums are available by special request.
Package styles for this die set in one, two or four channels are 8 and 16-Pin DIP thru hole, 16-Pin surface mount DIP flat pack, and 20 pad leadless ceramic chip carrier. Most devices are available with a variety of lead forms and plating options. See datasheet for details.
As the same die are used for each channel of each HCPL-653K device listed in the datasheet, absolute max ratings, recommended operating conditions, electrical specifications, and performance characteristics shown in the datasheet figures are virtually identical for all parts. Occasional exceptions exist due to package variations and limitations and are as noted. Additionally, the same package assembly processes and materials are used in all devices. These similarities give justification for the use of data obtained from one part to represent other parts performance for reliability and certain limited radiation test results.