HCPL-2502

Maximum Reverse Diode Voltage : 5 V
Packaging : Tube
Maximum Input Diode Current : 25 mA
Maximum Forward Diode Voltage : 1.7 V
Maximum Power Dissipation : 100 mW
Maximum Operating Temperature : + 70 C
Minimum Operating Temperature : 0 C
Maximum Baud Rate : 1 Mbps
Package / Case : PDIP-8
Current Transfer Ratio : 22 %


Features:

. 15 kV/s Minimum Common
   Mode Transient Immunity at
   VCM = 1500 V (4503/0453)
.  High Speed: 1 Mb/s
.  TTL Compatible
.  Available in 8-Pin DIP, SO-8,
   Widebody Packages
.  Open Collector Output
.  Guaranteed Performance
   from Temperature: 0°C to 70°C
.  Safety Approval UL Recognized   3750 V rms
   for 1 minute (5000 V rms for
   1 minute for HCNW and Option 020 devices) per UL1577 CSA Approved
   IEC/EN/DIN EN 60747-5-2 Approved
VIORM = 630 V peak for HCPL-4503#060
VIORM = 1414 V peak for HCNW devices
.  Dual Channel Version Available (253X/4534/053X/ 0534)
.  MIL-PRF-38534 Hermetic
   Version Available (55XX/65XX/4N55)


Application

. High Voltage Insulation
. Video Signal Isolation
. Power Transistor Isolation in Motor Drives
. Line Receivers
. Feedback Element in
  Switched Mode Power
  Supplies
. High Speed Logic Ground
  Isolation TTL/TTL, TTL/
  CMOS, TTL/LSTTL
. Replaces Pulse Transformers
. Replaces Slow
  Phototransistor Isolators
. Analog Signal Ground Isolation


Specifications

Parameter	Symbo	Device	Min.	Max.	Units	Note
Storage Temperature*	TS		-55	125	°C
Operating Temperature*	TA	8-Pin DIP SO-8	-55	100	°C
		Widebody	-55	85
Average Forward Input Current*	IF(AVG)			25	mA	1
Peak Forward Input Current* (50% duty cycle, 1 ms pulse width) (50% duty cycle, 1 ms pulse width)	IF(PEAK)	8-Pin DIP SO-8		50	mA	2
		Widebody		40
Peak Transient Input Current* ( 1 s pulse width, 300 pps)	IF(TRANS)	8-Pin DIPSO-8		1	A
		Widebody		0.1
Reverse LED Input Voltage* (Pin 3-2)	VR	8-Pin DIP SO-8		5	V
		Widebody		3
Input Power Dissipation*	PIN	8-Pin DIPSO-8		45	mW	3
		Widebody		40
Average Output Current* (Pin 6)	IO(AVG)			8	mA
Peak Output Current*	IO(PEAK)			16	mA
Emitter-Base Reverse Voltage* (Pin 5-7, except 4502/3, 0452/3)	VEBR			5	V
Supply Voltage (Pin 8-5)	VCC		-0.5	30	V
Output Voltage (Pin 6-5)	VO		-0.5	20	V
Supply Voltage* (Pin 8-5)	VCC		-0.5	15	V
Output Voltage* (Pin 6-5)	VO		-0.5	15	V
Base Current* (Pin 7, except 4502/3, 0452/3)	IB			5	mA
Output Power Dissipation*	PO			100	mW	4
Lead Solder Temperature* (Through-Hole Parts Only) 1.6 mm below seating plane, 10 seconds up to seating plane, 10 seconds	TLS	8-Pin DIP		260	°C
		Widebody		260	°C
Reflow Temperature Profile	TRP	SO-8 and Option 300	See Package Outline Drawings section

Description

These 6N135, HCPL-0500, and HCNW135  diode-transistor optocoup-lers use an insulating layer between a LED and an integrated photodetector to provide elec-trical insulation between input and output. Separate connections for the photodiode bias and output-transistor collector increase the speed up to a hundred times that of a conven- tional phototransistor coupler by reducing the base-collector capacitance. These single channel optocoup-lers are available in 8-Pin DIP,SO-8 and Widebody package configurations.

The 6N135, HCPL-0500, and HCNW135 are for use in TTL/ CMOS, TTL/LSTTL or wide bandwidth analog applications.Current transfer ratio (CTR) for these devices is 7% minimum at IF = 16 mA.

The 6N135, HCPL-0500, and HCNW135 are designed for high speed TTL/TTL applications. A standard 16 mA TTL sink current through the input LED will provide enoughoutput current for 1 TTL load and a 5.6 k? pull-up resistor. CTR for these devices is 19% minimum at IF = 16 mA.

The 6N135, HCPL-0500, and HCNW135 provide the electrical and switching performance of the 6N136,HCPL-0501, and HCNW136 with increased ESD protection.

The 6N135, HCPL-0500, and HCNW135  are similar to the HCPL-4502, HCPL-0452, and HCNW4502 optocouplers but have increased common mode transient immunity of 15 kV/s minimum at VCM = 1500 V guaranteed.

Parameters:

Technical/Catalog Information	HCPL-2502
Vendor	Avago Technologies US Inc.
Category	Isolators
Isolation Voltage	3750Vrms
Input Type	DC
Output Type	Transistor with Vcc
Current - Output/Channel	8mA
Voltage - Output	15V
Vce Saturation (Max)	-
Current Transfer Ratio (Min)	19% @ 16mA
Mounting Type	Through Hole
Package / Case	8-DIP
Packaging	Tube
Number of Circuits	1 - Single
Lead Free Status	Contains Lead
RoHS Status	RoHS Non-Compliant
Other Names	HCPL 2502 HCPL2502 516 1049 5 ND 51610495ND 516-1049-5