Features: •Stable at Gains of 2 or Greater
•Low AC Variability Over Process and Temperature
•Gain Bandwidth . . . . . . . . . . . . . . . . . . . . . . . . . . . 80MHz
•Gain Flatness to 10MHz. . . . . . . . . . . . . . . . . . . . 0.035dB
•High Slew Rate. . . . . . . . . . . . . . . . . . . . . . . . . . . 400V/s
•High Output Current (Min) . . . . . . . . . . . . . . . . . . . 100mA
•Differential Gain/Phase . . . . . . . . . . 0.02%/0.03 Degrees
•Low Supply Current (Max). . . . . . . . . . . . . . . . . . . . 15mA
•Enhanced Replacement for AD842Application•Pulse and Video Amplifiers
•Wideband Amplifiers
•Coaxial Cable Drivers
•Fast Sample-Hold Circuits
•High Frequency Signal Conditioning CircuitsPinout
SpecificationsVoltage Between V+ and V- Terminals. . . . . . . . . . . . . . . . . . . . 35V
Differential Input Voltage . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 6V
Output Current (Notes 3, 4). . . . . . . . . . . . . . . . . . . . . . . . . . 125mA
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .100mA (50% Duty Cycle)
3. VO = ±5V, RL Unconnected, Duty cycle 50%. For information about using high output current amplifiers, please refer to Application Note AN556 (Thermal Safe-Operating-Areas For High Current Op Amps), and the "Power Dissipation Considerations" section in the "Application Information" section of this datasheet.
4. Maximum continuous (100% Duty Cycle) output current is 50mA. For currents >50mA, Duty Cycle must be derated accordingly.
DescriptionThe HA-2842 is a wideband, high slew rate, operational amplifier featuring an outstanding combination of speed, bandwidth, and output drive capability. This amplifier's performance is further enhanced through stable operation down to closed loop gains of +2, the inclusion of offset null controls, and by its excellent video performance.
The capabilities of the HA-2842 are ideally suited for high speed cable driver circuits, where low closed loop gains and high output drive are required. With a 6MHz full power bandwidth, this amplifier is well suited for high frequency signal conditioning circuits and video amplifiers. Gain flatness of 0.035dB, combined with differential gain and phase specifications of 0.02%, and 0.03 degrees, respectively, make the HA-2842 ideal for component and composite video applications.
A zener/nichrome based reference circuit, coupled with advanced laser trimming techniques, yields a supply current with a low temperature coefficient and low lot-to-lot variability. For example, the average ICC variation from 85 to -40 is <600A (±2%), while the standard deviation of the ICC distribution is <0.1mA (0.8%) at 25. Tighter ICC control translates to more consistent AC parameters ensuring that HA-2842 units from each lot perform the same way, and easing the task of designing systems for wide temperature ranges. Critical AC parameters, Slew Rate and Bandwidth, each vary by less than ±5% over the industrial temperature range (see Typical Performance Curves)
HA-2842 Data Sheet
