G923

VIN to GND. . . . . . . . . . . . . . . . . . . . . . . . .-0.3V to 7V
Output Short-Circuit Duration . . . . . . . . . . . . . .Infinite
SET to GND . . . . . . . . . . . . . . . . . . . . . . . . -0.3V to 7V
SHDN to GND. . . . . . . . . . . . . . . . . . . . . . . -0.3V to 7V
SHDN to IN. . . . . . . . . . . . . . . . . . . . . . . . .-7V to 0.3V
OUT to GND. . . . . . . . . . . . . . . .  -0.3V to (V_IN + 0.3V)
Continuous Power Dissipation (T_A = 25)
SOT-23-5. . . . . . . . . . . . . . . . . . . . . .. . . . . . . 520mW
Operating Temperature Range . . . . . . . -40 to 85
Junction Temperature. . . . . . . . . . . . . . . . . . . . .150
Thermal Resistance Junction to Ambient, (_JA)
SOT-23-5. . . . . . . . . . . . . . . . . . . . . . . . 240/Watt⁽¹⁾
Storage Temperature Range. . . . . . . . .-65 to 160
Reflow Temperature (soldering, 10sec) . . . . . . .260

Note (1): See Recommended Minimum Footprint (Figure 3)
Stresses beyond those listed under "Absolute Maximum Ratings" may cause permanent damage to the device. These are stress ratings only, and functional operation of the device at these or any other conditions beyond those indicated in the operational sections of the specifications is not implied. Exposure to absolute maximum rating conditions for extended periods may affect device reliability.

The G923 is a low supply current, high PSRR, and low dropout linear regulator that comes in a space saving SOT-23-5 package. The supply current at no-load is 90A. In the shutdown mode, the maximum supply current is less than 1A. Operating voltage range of the G923 is from 2.50V to 5.50V. The over-current protection limit is set at 550mA typical. An over- temperature protection circuit is built-in in the G923 to prevent thermal overload. These power saving features make the G923 ideal for use in the battery-powered applications such as notebook computers,cellular phones, and PDA's.

The G923 has two modes of operation. When the SET pin is connected to ground, its output is a pre-set value: 1.50V~5.00V. There is no external component needed to decide the output voltage. When an output other than the preset value is needed, two external resistors should be used as a voltage divider. The output voltage is then decided by the resistor ratio. The G923 comes in a space saving SOT-23-5 package.