EL6277C

Features:

• Ultra-Small Package Outline
• High-performance laser diode driver
• Current-controlled output current source, 100 mA channel R and 2, 200mA channel 3, requiring one external set resistor per channel
• Rise time = 3.0 ns
• Fall time = 3.5ns
• On chip oscillator with frequency and amplitude control by use of external resistors to ground
• Oscillator to 500 MHz
• Oscillator to 100 mA pk/pk
• Single +5V supply (±10%)
• Current amplification = 100
• Disable feature for power-up protection and power savings
• TTL/CMOS control signals



Application

• CD-RW applications
• Writable optical drives
• Laser diode current switching



Pinout




Description

   The EL6277C is a high-performance three channel laser diode current driver that provides controlled current to a grounded laser diode. Channel R and 2 can provide 100mA per channel of DC or pulsed current, while channel 3 can provide 200mA per channel. Channels 2, and 3 must be used as the write channels, with switching speeds of approximately three nanosecond rise/fall time. All three channels are summed together at the IOUT output, allowing the user to create multilevel waveforms in order to optimize laser diode performance. The level of the output current is set by an analog voltage applied to an external resistor which converts the voltage into a current at the IIN pin (near ground). The current seen at this pin is then amplified by 100X to become a current source at pin IOUT.

   An on-chip 500 MHz oscillator EL6277C is provided to allow current modulation when in the read mode. This is turned on when the OSCEN pin is held high (floating not recommended). Complete control of amplitude and frequency is set by two external resistors connected to ground at pins RFREQ and RAMP (see graphs in this data sheet for further explanation). The oscillator will also turn off whenever either of the OUTEN pins for channels 2 or 3(the write channels) are low (see truth table).

   Output current pulses EL6277C are enabled when a 'Low' signal is applied to the OUTEN pin. No output current flows when OUTEN is 'H', and additional laser diode protection is provided since the OUTEN input will float high when open. Complete IOUT shut-off is also achieved by holding the ENABLE pin low, which will override the OUTEN control
pins.

The external resistors EL6277C allow the user to accurately and independently
set each amplifier trans conductance by applying a voltage to each
resistor, without restriction on the voltage range. Alternatively, the IIN
pin can be biased from a current DAC or other current source.