Features: • Specified for 3V, 5V, or ±5V applications
• Power-down to 0A (EL2157)
• Output voltage clamp (EL2157)
• Large input common mode range 0V < VCM < VS - 1.2V
• Output swings to ground without saturating
• -3dB bandwidth = 125MHz
• ±0.1dB bandwidth = 30MHz
• Low supply current = 5mA
• Slew rate = 275V/s
• Low offset voltage = 2mV max (SO package)
• Output current = ±100mA
• High open loop gain = 80dB
• Diff gain/phase = 0.05%/0.05°Application• Video amplifiers
• PCMCIA applications
• A/D drivers
• Line drivers
• Portable computers
• High speed communications
• RGB applications
• Broadcast equipment
• Active filteringPinout
SpecificationsSupply Voltage between VS+ and GND . . . . . . . . . . . . ..... . . . +12.6V
Input Voltage (IN+, IN-, ENABLE, CLAMP) . . . .......GND-0.3V, VS+0.3V
Differential Input Voltage . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .±6V
Maximum Output Current. . . . . . . . . . . . . . . . . . . . . . . . . ... . . . 90mA
Output Short Circuit Duration. . . . . . . . . . . . . . . . . . . . . . ... . (Note 1)
Power Dissipation . . . . . . . . . . . . . . . . . . . . . . . . . . . . . ...See Curves
Storage Temperature Range. . . . . . . . . . . . . . . . . .-65°C to +150°C
Ambient Operating Temperature Range . . . . . . . . . .-40°C to +85°C
Operating Junction Temperature. . . . . . . . . . . . . . . . . . ... . . . . 150°C
CAUTION: Stresses above those listed in "Absolute Maximum Ratings" may cause permanent damage to the device. This is a stress only rating and operation of the device at these or any other conditions above those indicated in the operational sections of this specification is not implied.
DescriptionThe EL2150 and EL2157 are the electronics industry's fastest single supply op amps available. Prior single supply op amps have generally been limited to bandwidths and slew rates ¼ that of the EL2150 and EL2157. The 125MHz bandwidth, 275V/s slew rate, and 0.05%/0.05° differential gain/differential phase makes this part ideal for single or dual supply video speed applications. With its voltage feedback architecture, these amplifiers can accept reactive feedback networks, allowing them to be used inanalog filtering applications. The inputs can sense signals below the bottom supply rail and as high as 1.2V below the top rail. Connecting the load resistor to ground and operating from a single supply, the outputs swing completely to ground without saturating. The outputs can also drive to within 1.2V of the top rail. The EL2150 and EL2157 will output ±100mA and will operate with single supply voltages as low as 2.7V, making them ideal for portable, low power applications.
The EL2157 has a high speed disable feature. Applying a low logic level to this pin reduces the supply current to 0A within 50ns. This is useful for both multiplexing and reducing power consumption.
The EL2157 also has an output voltage clamp feature. This clamp is a fast recovery (<7ns) output clamp that prevents the output voltage from going above the preset clamp voltage. This feature is desirable for A/D applications, as A/D converters can require long times to recover if overdriven. For applications where board space is critical the EL2150 is available in the tiny 5-pin SOT-23 package, which has a footprint 28% the size of an 8-pin SO. The EL2150 and EL2157 are both available in an 8-pin SO package. All parts operate over the industrial temperature range of -40°C to +85°C. For dual, triple, or quad applications, contact the factory.
EL2157 Data Sheet
