Features: • Optimized for 5V operation• Stable at gain of 1• 50MHz gain bandwidth product• 130V/s slew rate• Drives 150 load to video levels• Input and outputs operate at negative supply railApplication• Consumer video amplifier• Active filters/integ...
EL2110: Features: • Optimized for 5V operation• Stable at gain of 1• 50MHz gain bandwidth product• 130V/s slew rate• Drives 150 load to video levels• Input and outputs op...
SeekIC Buyer Protection PLUS - newly updated for 2013!
268 Transactions
All payment methods are secure and covered by SeekIC Buyer Protection PLUS.
Total Supply Voltage . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .. . ... . .18V
Input Voltage . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .. . . . -6VS
Differential Input Voltage . . . . . . . . . . . . . . . . . . . . . . . . . .. . . . . . .6V
Peak Output Current . . . . . . . . . . . . . . . . . . . . . ... .75mA per amplifier
Power Dissipation . . . . . . . . . . . . . . . . . . . . . . . . ...... .. . . See Curves
Storage Temperature Range . . . . . . . . . . . . . . . . . -65°C to +150°C
Operating Temperature Range . . . . . . . . . . . . . . . . ..-40°C to +85°C
CAUTION: Stresses above those listed in "Absolute Maximum Ratings" may cause permanent damage to the device. This is a stress only rating and operation of the device at these or any other conditions above those indicated in the operational sections of this specification is not implied.
The EL2110 operational amplifier, built using Elantec's complementary bipolar process, offers unprecedented high frequency performance at a very low cost. It is suitable for any application, such as consumer video, where traditional DC performance specifications are of secondary importance to the high frequency specifications. On a 5V supply at a gain of +1 the EL2110 will drive a 150 load to +2V, with a bandwidth of 50MHz. This device achieves 0.1dB bandwidth at 5MHz.
The recommended power supply voltage is 5V. At zero and 5V supplies, the inputs will operate to ground. When the outputs are at 0V the amplifier draws only 2.4mA of supply current.