EBD11UD8ABFB

Features:

• 184-pin socket type dual in line memory module (DIMM) 
        -PCB height:  31.75mm 
        -Lead pitch:  1.27mm
• 2.5V power supply
• Data rate: 333Mbps/266Mbps (max.)
• 2.5 V (SSTL_2 compatible) I/O
• Double Data Rate architecture; two data transfers per clock cycle 
• Bi-directional, data strobe (DQS) is transmitted /received with data, to be used in capturing data at the receiver 
• Data inputs and outputs are synchronized with DQS 
• 4 internal banks for concurrent operation  (Component)
• DQS is edge aligned with data for READs; center aligned with data for WRITEs
•  Differential clock inputs (CK and /CK)
•  DLL aligns DQ and DQS transitions with CK transitions
• Commands entered on each positive CK edge; data  referenced to both edges of DQS
• Auto precharge option for each burst access
• Programmable burst length:  2, 4, 8
• Programmable /CAS latency (CL):  2, 2.5
• Refresh cycles:  (8192 refresh cycles /64ms) 
        -7.8µs maximum average periodic refresh interval
• 2 variations of refresh 
        -Auto refresh 
        -Self refresh 


Specifications

Parameter	Symbol	Value	Unit	Note
Voltage on any pin relative to VSS	VT	-0.5 to +3.6	V
Supply voltage relative to VSS	VDD, VDDQ	-0.5 to +3.6	V
Short circuit output current	IO	50	mA
Power dissipation	PD	16	W
Operating ambient temperature	TA	0 to +70		1
Storage temperature	Tstg	-55 to +125

Description

The  EBD11UD8ABFB  is  128M  words  ×  64  bits,  2  banks  Double  Data  Rate  (DDR)  SDRAM  unbuffered  module, mounted 16 pieces of 512M bits DDR SDRAM  sealed  in TSOP package.  Read and write  operations  are  performed  at  the  cross  points  of  the  CK  and  the  /CK.  This high-speed data transfer EBD11UD8ABFB is realized by the 2 bits prefetch-pipelined architecture.  Data strobe (DQS)  both for read and write are available for high speed and  reliable  data  bus  design.    By  setting  extended  mode register, the on-chip Delay Locked Loop (DLL) can be  set  enable  or  disable.    This  module  provides  high  density  mounting  without  utilizing  surface  mount  technology.    Decoupling  capacitors  are  mounted  beside each TSOP on the module board.