Description
Features:
Complies with Open LDI and GMCH DVO specification for digital display interfaces
25 to 65 MHz clock in single pixel in to single pixel out coperation.
50 to 130 MHz clock in single pixel in to dual pixel out coperation.
Support 24bit/48bit color TFT LCD with Conventional and Non-Conventional Color Mappings.
Support 16bit/32bit color TFT LCD.
Single pixel transmitter inputs support single pixel GUI interface.
Up scaling/panel fitting supports VGA to SXGA+ output in single pixel input mode at 640x480@60Hz, 800x600@60Hz, 1024x768@60Hz, 1280x1024@60Hz,
Independent horizontal and vertical scaling.
Support dithering (available for 6-bit color only), programmable smoothing and anti-aliasing filter.
Programmable digital sharpness, edge enhancement and contrast control via gamma correction.
Allow 2% at 200KHz spread spectrum clocking, rejects cycle-to-cycle jitter (+/− 20% of input data bit time).
Programmable LCD panel power sequencing.
Support low voltage swing signal level (1V to 1.8V),2.5V and 3.3V LVTTL level on CLKINP, CLKINM, D0 to
D23, DE, HSYNC and VSYNC pins
Support 2.5V/3.3V LVTTL level on configuration pins
Support 3.3V LVTTL level on GPIO pins
Available in 10mm x 10mm x 1mm 128pin thermally enhanced CSP package.
Two-wire serial communication interface is active during normal as well as power down mode and support data rates up to 400KHz.TIA/EIA-644, Open LDI, DVO compliance.
Specifications
If Military/Aerospace specified devices are required,please contact the National Semiconductor Sales Office/
Distributors for availability and specifications.
Supply Voltage (VCC) −0.3V to +2.8V
Supply Voltage (VCC3V) −0.3V to +3.6V
CMOS/TTL Input Voltage −0.3V to VCC3V
CMOS/TTL Output Voltage −0.3V to (VCC + 0.3V)
LVDS Driver Output Voltage −0.3V to (VCC + 0.3V)
LVDS Output Short
Circuit Duration Continuous
Junction Temperature +150˚C
Storage Temperature −65˚C to +150˚C
Lead Temperature
(Soldering, 4 sec.) +260˚C
Description
The DS90C2501 is a highly integrated scaling IC with LVDS transmitter with a scaled resolution up to SXGA+ for single pixel input. The DS90C2501 is a video controller hub designed to be compatible with Graphic Memory Controller Hub (GMCH). The input interface can be single or dual DVO port (12 pin per port). The high quality cubic zoom engine scales the input graphics into the desired/optimal output resolution up to 1400x1050 resolution. Advanced video digital signal processing provides gamma correction, and dithering for the display output. A two-wire serial interface is used to communicate with the host system. The dual high speed LVDS channels supports single pixel in-single pixel out, single pixel in-dual pixel out, and dual pixel in-dual pixel out transmission modes. The DS90C2501 complies to Open LDI standard, and can be paired up with DS90CF388 receiver or FPD8531x/FPD8731x series integrated timing controller or FPDLink LVDS receivers such as DS90CF364/DS90CF384A/DS90CF384/DS90CF384A. The LVDS output is similar to DS90C387 and DS90C387R. Thus, this transmitter can be paired up with DS90CF388, receiver of 112MHz LDI chipset or FPD-Link Receivers in non-DC Balance mode operation which provides GUI/LCD panel/mother board vendors a wide choice of inter-operation with LVDS based TFT panels.
This chip DS90C2501 is an ideal solution to solve EMI and cable size problems for high-resolution flat panel applications. It provides a reliable industry standard interface based on LVDS technology that delivers the bandwidth needed for high- resolution panels while maximizing bit times, and keeping clock rates low to reduce EMI and shielding requirements.
For more details about DS90C2501, please refer to the "Applications Information" section of this datasheet.
DS90C2501 Data Sheet
