DS2482-800

· I²C Host Interface, Supports 100kHz and 400kHz I²C Communication Speeds
· 1-Wire Master I/O with Selectable Active or Passive 1-Wire Pullup
· Provides Reset/Presence, 8-Bit, Single-Bit, and Three-Bit 1-Wire I/O Sequences
· Eight Channels of Independently Operated 1-Wire I/O
· Standard and Overdrive 1-Wire Communication Speeds
· Slew Controlled 1-Wire Edges
· Selectable 1-Wire Slave Presence Pulse Falling Edge Masking to Control Fast Edges on the 1-Wire Line
· Supports Low-Impedance 1-Wire Strong Pullup for EEPROMs, Temp Sensors, or Other 1-Wire Slaves That Have Momentary High Current Modes
· Three Address Inputs for I²C Address Assignment
· Wide Operating Range: 2.9V to 5.5V, -40°C to +85°C
· 16-Pin SO Package (150 mil)

The DS2482-800 is an I²C™ to 1-Wire
bridge device that interfaces directly to standard (100kHz max) or fast (400kHz max) I²C masters to perform bidirectional protocol conversion between the I²C master and any downstream 1-Wire slave devices. Relative to any attached 1-Wire slave device, the DS2482-800 is a 1-Wire master. Internal factorytrimmed timers relieve the system host processor from generating time-critical 1-Wire waveforms, supporting both standard and Overdrive 1-Wire communication speeds. To optimize 1-Wire waveform generation, the DS2482-800 performs slew-rate control on rising and falling 1-Wire edges and has a programmable feature to mask the fast presence pulse edge that some 1-Wire slave devices can generate. Programmable strong pullup features support 1-Wire power delivery to 1-Wire devices such as EEPROMs and sensors. The DS2482-800 combines these features with eight independent 1- Wire I/O channels. The I²C slave address assignment is controlled by three binary address inputs, resolving potential conflicts with other I²C slave devices in the system.