DM74ALS373

Supply Voltage ..........................................................7V
Input Voltage ............................................................7V
Voltage Applied to Disabled Output .......................5.5V
Operating Free Air Temperature Range ...0°C to +70°C
Storage Temperature Range ..............-65°C to +150°C
Typical _JA N Package ....................................57.0°C/W
Typical _JA M Package ....................................76.0°C/W

Note 1: The "Absolute Maximum Ratings" are those values beyond which the safety of the device cannot be guaranteed. The device should not be operated at these limits. The parametric values defined in the Electrical Characteristics tables are not guaranteed at the absolute maximum ratings. The "Recommended Operating Conditions" table will define the conditions for actual device operation.

These 8-bit DM74ALS373 registers feature totem-pole 3-STATE outputs designed specifically for driving highly-capacitive or relatively low-impedance loads. The high-impedance state and increased high-logic-level drive provide these DM74ALS373 registers with the capability of being connected directly to and driving the bus lines in a bus-organized system without need for interface or pull-up components. They are particularly attractive for implementing buffer registers, I/O ports, bidirectional bus drivers, and working registers.

The eight latches of the DM74ALS373 are transparent Dtype latches. While the enable (G) is HIGH the Q outputs
will follow the data (D) inputs. When the enable is taken LOW the output will be latched at the level of the data that was set up.

A buffered output control input can be used to place the eight outputs in either a normal logic state (HIGH or LOW
logic levels) or a high-impedance state. In the high-impedance state the outputs of DM74ALS373 neither load nor drive the bus lines significantly.

The output control does not affect the internal operation of the latches. That is, the old data can be retained or new data can be entered even while the outputs are OFF.