CY7C09569V-67AXC

The CY7C09569V-67AXC  is  high-speed 3.3V synchronous CMOS 16K and 32K x 36 dual-port static RAMs. Two ports are provided, permitting independent, simultaneous access for reads and writes  to any location in memory. Registers on control, address, and data lines allow for minimal set-up and hold times. In pipelined output mode, data ofCY7C09569V-67AXC is registered for decreased cycle time. Clock to data valid tCD2 = 5 ns (pipelined). Flow-through mode can also be used to bypass the pipelined output register to eliminate access latency. In flow-through mode data will be available tCD1 = 12.5 ns after the address is clocked into the device. Pipelined output or flow-through mode is selected via the FT/Pipe pin.

Features of the CY7C09569V-67AXC  are:(1)True dual-ported memory cells which allow simultaneous access of the same memory location; (2)Two Flow-Through/Pipelined devices- 16K x 36 organization (CY7C09569V)- 32K x 36 organization (CY7C09579V); (3)0.25-micron CMOS for optimum speed/power; (4)Three  modes- Flow-Through- Pipelined- Burst; (5)Bus-Matching Capabilities on Right Port(x36 to x18 or x9); (6)Byte-Select Capabilities on Left Port; (7)100-MHz Pipelined Operation; (8)High-speed clock to data access 5/6/8 ns ; (9)3.3V Low operating power --Active = 250 mA (typical)-Standby = 10 A (typical); (10)Fully synchronous interface for ease of use; (11)Burst counters increment addresses internally- Shorten cycle times- Minimize bus noise- Supported in Flow-Through and Pipelined modes; (12)Counter Address Read Back via I/O lines; (13)Single Chip Enable; (14)Automatic power-down; (15)Commercial and Industrial Temperature Ranges; (16)Compact package- 144-Pin TQFP (20 x 20 x 1.4 mm)- 144-Pin Pb-Free TQFP (20 x 20 x 1.4 mm)- 172-Ball BGA (1.0-mm pitch) (15 x 15 x 0.51 mm).

The absolute maximum ratings of the CY7C09569V-67AXC   can be summarized as:(1)Storage Temperature: 65°C to +150°C; (2)Ambient Temperature with Power Applied:55°C to +125°C; (3)Supply Voltage to Ground Potential :0.5V to +4.6V; (4)DC Voltage Applied to Outputs in High Z State:0.5V to VDD+0.5V; (5)DC Input Voltage:0.5V to VDD+0.5V; (6)Output Current into Outputs (LOW):20 mA; (7)Static Discharge Voltage: >2001V; (8)Latch-Up Current:>200 mA.

If you want to know more information such as the electrical characteristics ,please download the datasheet in www.seekdatasheet.com .