AmPDL128G

Storage Temperature
Plastic Packages . . . . . . . . . . . . . . .65°C to +150°C
Ambient Temperature
with Power Applied . . . . . . . . . . . . 65°C to +125°C
Voltage with Respect to Ground
V_CC (Note 1) . . . . . . . . . . . . . . . . ....0.5 V to +4.0 V
A9, OE#, and RESET#
(Note 2) . . . . . . . . . . . . . . . . . . . ...0.5 V to +12.5 V
ACC (Note 2) . . . . . . . . . . . . . . ......0.5 V to +10.5 V
All other pins (Note 1) . . . . . . ...0.5 V to V_CC +0.5 V
Output Short Circuit Current (Note 3) . . . . . . 200 mA

Notes:
1. Minimum DC voltage on input or I/O pins is 0.5 V. During voltage transitions, input or I/O pins may overshoot V_SS to 2.0 V for periods of up to 20 ns. Maximum DC voltage on input or I/O pins is V_CC +0.5 V.  See Figure 7. During voltage transitions, input or I/O pins may overshoot to V_CC +2.0 V for periods up to 20 ns. See Figure 8.
2. Minimum DC input voltage on pins A9, OE#, RESET#, and ACC is 0.5 V. During voltage transitions, A9, OE#, ACC, and RESET# may overshoot V_SS to 2.0 V for periods of up to 20 ns. See Figure 7. Maximum DC input voltage on pin A9, OE#, and RESET# is +12.5 V which may overshoot to +14.0 V for periods up to 20 ns. Maximum DC input voltage on ACC is +9.5 V which may overshoot to +12.0 V for periods up to 20 ns.
3. No more than one output may be shorted to ground at a time. Duration of the short circuit should not be greater than one second.

Stresses above those listed under "Absolute Maximum Ratings" may cause permanent damage to the device. This is a stress rating only; functional operation of the device at these or any other conditions above those indicated in the operational sections of this data sheet is not implied. Exposure of the device to absolute maximum rating conditions for extended periods may affect device reliability.

The AmPDL128G is a 128 Mbit, 3.0 volt-only Page Mode and Simultaneous Read/Write Flash memory device organized as 8 Mwords or 4 M double words (One word is equal to two bytes). The device is offered in an 80-ball Fortified BGA package. The word-wide data (x16) appears on DQ15-DQ0; the double word mode data (x32) appears on DQ31-DQ0. This device can be programmed in-system or in standard EPROM programmers. A 12.0 V V_PP is not required  for write or erase operations.

AmPDL128G offers fast page access times of 25 and 30 ns, with corresponding random access times of 70 and 80 ns, respectively, allowing high speed microprocessors to operate without wait states. To eliminate bus contention the device has separate chip enable (CE#), write enable (WE#)  nd output enable (OE#) controls.